The Natural Resources Conservation Board Service Area dataset is comprised of all the polygons that represent Natural Resources Conservation Board Service Areas in Alberta. The dataset is the administrative boundary for the 4 regional offices of Natural Resources Conservation Board.

The Forest Protection Area dataset is comprised of all the polygons that represent the administrative areas established by Forest Protection, Forestry Division of Alberta Agriculture and Forestry concerned with the prevention and control of damage to forests from fire, insects, disease and other harmful agents.

This dataset is produced for the Government of Alberta and is available to the general public. The Forest Management Agreement (FMA) Published Area dataset consists of polygons representing the areas of land where the Province of Alberta grants FMA holders the rights to establish, grow, harvest, and remove timber in accordance with the relevant regulations and policies. Please note that the distribution contact differs for the general public compared to Government of Alberta ministries. Refer to the Distribution Information section of this metadata for the appropriate contact to acquire this dataset.

This data collection contains various historical features within Alberta related to the Dominion Forestry Branch (DFB), and the early days of the Alberta Forest Service (AFS). The data collection consists of the following: Historical Forest Reserve Boundaries (1900 to 1930). Timber Berth boundaries (1910 to 1923). Early Ground and Aerial Fire Patrol Routes. Air Stations (1920s). Locations of DFB Forest Surveys (1910 to 1915). AFS Forest and District Boundaries (circa 1938). These datasets provide approximate locations of the features they represent and are intended for use in medium to small-scale mapping. No spatial accuracy tests were conducted on any of the data. Features derived from land locations tied in the Alberta Township System (ATS) are likely to be accurate providing there were no errors in transcribing the locations. However features digitized from old maps will have poor spatial accuracy ranging from several kilometres to a few hundred metres, depending on the map scale, map projection, and the accuracy of the features on the source map.

The Urban Service Area dataset is comprised of all the polygons that represent Urban Service Areas in Alberta. Urban Service Area is a municipality type defined under the authority of the Municipal Government Act. The formation of an Urban Service Area can occur if there is a large unincorporated community within a Specialized Municipality that is recognized as an equivalent to a City by the Government of Alberta. It has a population, public utility services, and other characteristics.

Represents timber supply area and other land use boundaries in the province of Saskatchewan. Timber supply areas are the primary management unit used for the allocation of timber harvest, licensing, forest management planning and harvest volume schedules.The Saskatchewan Ministry of Environment regulates forestry activities on Crown “forest lands” — as defined by The Forest Resources Management Act — using several types of licenses and permits:  Forest Management Agreement (FMA)A forest management agreement is a 20-year agreement, typically with a larger forest company, conferring long-term harvesting rights for a specific volume of timber from a defined area, as well as responsibilities for long-term sustainable forest management. Term Supply Licence (TSL)A term supply licence (TSL) is a licence with a term of up to 10 years, granting rights to harvest specified forest volumes as well as responsibilities for forest management. A TSL may be volume-based or area-based.  Forest Product Permit (FPP)A forest product permit grants the right to harvest specified forest products for a term of up to one year. This permit is also used to regulate other activities, such as grazing in the forest. Land use is classified into three categories:  Commercial ForestAreas within the provincial forest that are available for commercial timber harvest allocation through the use of forest management agreements (FMA), volume-based or area-based term supply licences (TSL), or forest product permits (FPP).  Fringe ForestAreas, generally south of the provincial forest, that contain “forest lands” — as defined by The Forest Resources Management Act. Within the fringe forest, harvest allocations are administered by the Ministry of Environment through the use of forest product permits and volume-based term supply licenses.  Other UsesAreas within the provincial forest that are not available or suitable for forestry activities. These include protected areas and areas generally north of the commercial forest.  For the entire Canwood, Nisbet, Fort a la Corne, Torch River, and Porcupine Provincial Forests, and the southern portion of the Northern Provincial Forest, boundaries follow the textual descriptions found in The Forest Resources Management Regulations, F-19.1 Reg 1, amended June 2020. Commercial forest and fringe forest areas are sub-divided into timber supply areas. Forest Names and Licence Holders are current as of August 31, 2020.

This feature class represents Manitoba's Forest Management Licence (FML) boundaries.The Forest Act provides for the establishment of Forest Management Licences to provide a continuous supply of timber to the forest industry. A Forest Management Licence, granted for a period of not more than twenty years, may be renewed for further periods. The Forest Management Licence describes the land upon which trees may be cut, the volume of wood that may be harvested, and other terms and conditions. There are currently two Forest Management Licences in Manitoba, FML-2 and FML-3 . Timber management and forest renewal are the responsibilities of Manitoba Sustainable Government on Crown Forest Land outside of Forest Management Licence areas, and within Forest Management Licence areas where the wood is used by a facility other than that operated by the Forest Management Licensee. Version 3 of Manitoba's Forest Management Licence (FML) boundaries includes FML-2 and FML-3. Previous boundaries associated with FML-1 and IWSA's have been removed. To update and improve the positional accuracy of Manitoba's Forest Management Licence (FML) boundaries, written descriptions of FML areas were referenced along with linework from Forest Land Inventories (FLI), Forest Resource Inventories (FRI) and Manitoba's township fabric to improve Provincial FML boundaries. Boundary linework the following related geospatial datasets were topologically checked for coincident linework: Manitoba Provincial Boundary; Manitoba Forest Management Units ; Manitoba Forest Management Licence Agreement Areas; Manitoba Forest Sections; Manitoba Provincial Forests . Fields Included: FML_NAME : Forest Management Licence area name.

Ontario's Crown forest is divided into geographic planning areas, known as forest management units. Most of these units are managed by individual forest companies under a Sustainable Forest License. A forest management unit is identified by an assigned official name (e.g., Black Spruce Forest) and a unique numeric code. Before any forestry activities can take place in a management unit, there must be an approved forest management plan in place for each management unit. Instructions for downloading this dataset: This product requires the use of geographic information system (GIS) software.

This is a spatial layer showing Ministry of Forests Managed LIcences. These are Community Forest Schedule A and B, Woodlot License Schedule A and B. The Forest Tenures Section (FTS) is responsible for the creation and maintenance of digital Forest Atlas files for the province of British Columbia encompassing Forest and Range

Manitoba's Forest Management Licence Area (FML) Boundaries – Version 4.The Forest Act provides for the establishment of Forest Management Licences to provide a continuous supply of timber to the forest industry. A Forest Management Licence, granted for a period of not more than 20 years, may be renewed for further periods. The Forest Management Licence describes the land upon which trees may be cut, the volume of wood that may be harvested, and other terms and conditions. There are currently three Forest Management Licences in Manitoba. Timber management and forest renewal are the responsibilities of Manitoba Conservation on Crown Forest Land outside of Forest Management Licence areas, and within Forest Management Licence areas where the wood is used by a facility other than that operated by the Forest Management Licensee. Version 4 of Manitoba's Forest Management Licence (FML) boundaries incorporates minor edits made to the BDY_MB_FMU_PY feature class, ensuring coincident line work with the provincial boundary and provincial forests. Version 3 of Manitoba's Forest Management Licence (FML) boundaries includes FML-2 and FML-3. Previous boundaries associated with FML-1 and IWSAs have been removed. To update and improve the positional accuracy of Manitoba's Forest Management Licence (FML) boundaries, written descriptions of FML areas were referenced along with line work from Forest Land Inventories (FLI), Forest Resource Inventories (FRI) and Manitoba's township fabric to improve p rovincial FML boundaries. Boundary line work for all of the following feature classes were topologically checked for coincident line work: 1. BDY_MB_FMU_PY (Provincial FMUs); 2. Provincial Boundary; 3. BDY_MB_FML_PY (Provincial Forest Management Licence Areas); 4. BDY_MB_FOREST_SECTION_PY (Provincial Forest Sections); 5. BDY_MB_PROV_FOREST_PY (Provincial Forests)   The dataset includes the following fields /Les ensembles de données comprennent les champs suivants Name / Nom Alias Description FML FML Forest Management Licence Area number Numéro de zone de gestion forestière visée par une licence FML_NAME FML Name / Nom Forest Management Licence Area name Nom de zone de gestion forestière visée par une licence AREA_HA Area / Surface (Hectares) Area in hectares La surface en hectares   Limites des zones de gestion forestière du Manitoba visées par une licence – Version 4