This product provides the Earth conductivity models for the varying conductivity zones throughout the ten Canadian provinces. The earth conductivity models are derived from a review of published results from magnetotelluric (MT) surveys.NRcan has developed a set of over 70 Earth conductivity models for use in calculating the effect of geomagnetic storms on power systems.

Hydraulic properties characterize a hydrogeological unit. The hydraulic properties considered for this dataset are the transmissivity, the hydraulic conductivity, the storage coefficient, the specific storage coefficient and the porosity. Hydraulic properties are estimated by performing aquifer tests (pumping tests, slug tests). The hydraulic tests and their duration are managed in this dataset. The methods used to create the dataset are described in the metadata associated with the dataset. The dataset exhibits a general description of hydraulic properties of the hydrogeological unit, including hydraulic test, total test duration, method and date. It includes numbers and/or ranges describing the aquifer tests results. Note that an alternate raster representation could be used in complement to the discrete point-based representation.

This dataset includes water chemistry data collected from five of the six lakes as part of the Northwestern Ontario Size Series project in 1987 and 1990 including species of nitrogen and phosphorus, carbon, chlorophyll a, conductivity, soluble reactive silica, chloride, sulphate, conductivity, sodium, potassium, magnesium, calcium, pH, alkalinity and organic acids

The theme on physicochemical monitoring of rivers and rivers presents data from all stations in networks monitoring water quality in rivers in Quebec and the St. Lawrence River.The purpose of networks for monitoring general water quality is to characterize, using current physicochemical and bacteriological parameters, the quality of water in spatial terms and to monitor the evolution of this quality over time. For the regular monitoring of the general quality of river and river water, the parameters measured are: total phosphorus, total nitrogen, nitrites and nitrates, ammonia nitrogen, chlorophyll a, pheopigments, faecal coliforms, faecal coliforms, turbidity, suspended matter, pH, conductivity, dissolved organic carbon and temperature. This data is used to calculate the Bacteriological and Physicochemical Water Quality Index (IQBP), a water quality classification index.The data set on physicochemical monitoring of rivers and rivers also includes the drainage areas of some of the stations. The attribute table provides a compilation of land use by category for the last year available at the time the data was generated. Follow-up is carried out annually.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

This dataset represents the location of the North American Central Plains conductivity anomaly of the Province of Saskatchewan.This dataset represents the location of the North American Central Plains conductivity anomaly of the Province of Saskatchewan. The data was created as a file geodatabase feature class and output for public distribution. **Please Note – All published Saskatchewan Geological Survey datasets, including those available through the Saskatchewan Mining and Petroleum GeoAtlas, are sourced from the Enterprise GIS Data Warehouse.  They are therefore identical and share the same refresh schedule. 

This project was completed by the Coastal Environmental Baseline Program (Coastal and Freshwater Ecology Section) in the Newfoundland and Labrador Science Branch of Fisheries and Oceans Canada (DFO). From 2020-2023, there were semi-annual deployments and retrievals of 3 moored CTDs in the bay. From 2020 to November 2021, moored CTDs collected hourly recordings of conductivity, temperature and pressure. From 2021 through 2023, these CTDs collected year-round, hourly, information on temperature, conductivity, pressure, dissolved oxygen, and chlorophyll-a. Acoustic releases also collected hourly ambient noise (mV) data. This record contains the geographic locations of the sites, and information on the timings and types of data collected at each site.

The Coastal Environmental Baseline Program is a multi-year Fisheries and Oceans Canada initiative designed to work with Indigenous and local communities and other key parties to collect coastal environmental data at a series of sites across Canada, to build a better understanding of existing marine ecological conditions. The program began data collection in 2019, and with the onset of Phase 2 in 2023, the Maritimes region study area was expanded and renamed ‘Northwest Fundy Shores’. A physical oceanography program was designed to align with the oceanographic interests and data needs of local interest holders. Starting in 2023, oceanographic parameters including water temperature, salinity, depth and turbidity have been monitored at a series of locations in Passamaquoddy Bay, the St. Croix River, and along the Bay of Fundy coast, including the Musquash estuary Marine Protected Area (MPA). This dataset includes seasonal CTD (conductivity, temperature and depth) and turbidity data starting in spring 2023. Instruments are maintained through the winter months at a limited number of sites. Data collection methods are primarily moored instruments on the bottom in water depths of 5-90 meters, and a few buoyant surface floats. Overall, this dataset captures seasonal dynamics in near-shore marine environments in Passamaquoddy Bay, the St Croix River, the Bay of Fundy and the Musquash MPA. Cite this data as: Coastal Environmental Baseline Program (Maritimes Region), Northwest Fundy Shores conductivity, temperature and depth data. Published in May 2025. Coastal Environmental Baseline Program. Coastal Ecosystems Science Division, Fisheries and Oceans Canada, St. Andrews, N.B. 14-02-2025

A systematic oceanographic monitoring program was initiated in September 1989 at twenty-five monitoring stations in the Passamaquoddy Bay area and approaches by Dr. Shawn Robinson based out of the St. Andrews Biological Station (SABS). Stations were established in a uniform grid pattern of two arcminutes latitude and longitude over the study area in order to develop a database on the spatial patterns of water properties. Monthly measurements of the water column for the temperatures and salinity at all stations was completed using a Seacat SBE 19 internally recording CTD from Sea-bird Electronics Inc. The CTD was programmed to record conductivity, temperature, and depth at a frequency of 2 hz, corresponding to 2 measurements per meter of water depth. CTD casts were recorded for each of the 25 stations in the study area monthly using the R/V Pandalus, and later the CCGS Viola M. Davidson based out of SABS. The CTD was configured such that the sensors were oriented towards the benthos and the CTD was then attached to a hydraulic winch on the deck of the ship by a stainless steel cable one meter above a weight, and lowered 1 m below the water's surface in order for the CTD to equilibrate for one minute. The CTD was then lowered at 1 m/s to the benthos using a metered block on the winch to determine when the CTD had reached the maximum depth at that station. Once the weight had touched the bottom, the CTD was retrieved from the water, turned off, and placed in a bucket of fresh seawater in order to minimize equilibration time at the next station. Initially, the CTD measured salinity via water forced through the salinity cell with the drop rate of 1 m/s, but in August 1992, a pump was mounted on the CTD in order to provide a more consistent flow of water across the salinity cell. Surface temperatures were measured from bucket samples collected upon arriving at each station using a hand-held mercury thermometer at each station, and Secchi disk measurements were recorded. All data were downloaded from the CTD upon return to SABS using a DFO computer and the proprietary Sea-Soft software. Downcast data from each profile was retained, binned into 1 m intervals, and processed to remove data spikes, density inversions, and anomalies due to inadequate instrument equilibration. Processed data was then stored in the DFO's Oracle database (PTRAN) under the IMTA_SABS schema in the INVHYD and INVINF tables. Station numbers and locations are recorded in the CTD_STATIONS table in the IMTA_SABS schema.Cite this data: Robinson, S. Data of: Passamaquoddy Bay monthly Conductivity Temperature and Depth (CTD) sampling (1989 - 2018). Published: October 2019. Coastal Ecosystems Science Division, Fisheries and Oceans Canada, St. Andrews, NB. https://open.canada.ca/data/en/dataset/12184962-7879-4214-aef0-b31162f04a27

The Coastal Environmental Baseline Program is a multi-year Fisheries and Oceans Canada initiative designed to work with Indigenous and local communities and other key parties to collect coastal environmental data at six pilot sites across Canada (Port of Vancouver, Port of Prince Rupert, Lower St. Lawrence Estuary, Port of Saint John, Placentia Bay, and Iqaluit). The goal of the Program is to gather local information in these areas in effort to build a better understanding of marine ecological conditions. The Maritimes region has developed a physical oceanography program to align with the oceanographic interests and data needs of local communities and stakeholders, with the goal of sharing this information via open data. Starting in 2019, oceanographic parameters including temperature, salinity, depth, turbidity and currents have been continuously monitored at a series of locations covering a broad range of environments in the Port of Saint John and approaches vicinity, including the lower Saint John and Kennebecasis rivers, coastal fringe marshes and embayments, as well as the Musquash estuary Marine Protected Area (MPA). This dataset includes CTD data starting in 2019 and turbidity data from August 2020. Data collection methods range from bottom-mounted instruments in water depths of 10-50 meters, buoyant surface moorings, and hard-mounted instruments in intertidal zones. Intertidal data is interrupted during some low tide events, where the water level drops below the sensor, resulting in loss of functionality for periods up to 1-2 hours. Overall this dataset captures a dynamic balance between salt and fresh water on the highly tidal lower Saint John river, coastal seasonal dynamics in near-shore marine environments in the Musquash MPA, and the constant fluctuations of intertidal creeks and marshes.Update 2 - April 2025: included 2023-24 dataUpdate 1 - Nov 2023: included 2022 data; removed daylight savings errors from 2019, 2020 and 2021; updated position for Evandale surface mooring.

Description:Seasonal climatologies (temperature, salinity, and sigma-t) of the Northeast Pacific Ocean were computed from historical observations including all available conductivity-temperature-depth (CTD), bottle, expendable bathy-thermograph (XBT), and Argo data in NOAA (http://www.argo.ucsd.edu/), Marine Environmental Data Service (MEDS), and Institute of Ocean Sciences archives over 1980 to 2010 period in spatial resolution ranging from approximately 100m to 70km.Methods:Calculations, including smooth and interpolation, were carried out in sixty-five subregions and up to fifty-two vertical levels from surface to 5000m. Seasonal averages were computed as the median of yearly seasonal values. Spring months were defined as April to June, summer months were defined as July to September, fall months were defined as October to December, and winter months were defined as January to March.Uncertainties:Uncertainties are introduced when quality controlled observational data are spatially interpolated to varying distances from the observation point. Climatological averages are calculated from these interpolated values.