Winter limnologoy (mean oxygen) sites in the Cariboo Region

The fire regime describes the patterns of fire seasonality, frequency, size, spatial continuity, intensity, type (e.g., crown or surface fire) and severity in a particular area or ecosystem.The number of large fires refers to the annual number of fires greater than 200 hectares (ha) that occur per units of 100,000 ha. It was calculated per Homogeneous Fire Regime (HFR) zones. These HFR zones represent areas where the fire regime is similar over a broad spatial scale (Boulanger et al. 2014). Such zonation is useful in identifying areas with unusual fire regimes that would have been overlooked if fires had been aggregated according to administrative and/or ecological classifications.Fire data comes from the Canadian National Fire Database covering 1959–1999 (for HFR zones building) and 1959-1995 (for model building). Multivariate Adaptive Regression Splines (MARS) modeling was used to relate monthly fire regime attributes with monthly climatic/fire-weather in each HFR zone. Future climatic data were simulated using the Canadian Earth System Model version 2 (CanESM2) and downscaled at a 10 Km resolution using ANUSPLIN for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: projected number of large fires (>200 ha) across Canada for the long-term (2071-2100) under the RCP 8.5 (continued emissions increases).Reference: Boulanger, Y., Gauthier, S., et al. 2014. A refinement of models projecting future Canadian fire regimes using homogeneous fire regime zones. Canadian Journal of Forest Research 44, 365–376.

The fire regime describes the patterns of fire seasonality, frequency, size, spatial continuity, intensity, type (e.g., crown or surface fire) and severity in a particular area or ecosystem.The number of large fires refers to the annual number of fires greater than 200 hectares (ha) that occur per units of 100,000 ha. It was calculated per Homogeneous Fire Regime (HFR) zones. These HFR zones represent areas where the fire regime is similar over a broad spatial scale (Boulanger et al. 2014). Such zonation is useful in identifying areas with unusual fire regimes that would have been overlooked if fires had been aggregated according to administrative and/or ecological classifications.Fire data comes from the Canadian National Fire Database covering 1959–1999 (for HFR zones building) and 1959-1995 (for model building). Multivariate Adaptive Regression Splines (MARS) modeling was used to relate monthly fire regime attributes with monthly climatic/fire-weather in each HFR zone. Future climatic data were simulated using the Canadian Earth System Model version 2 (CanESM2) and downscaled at a 10 Km resolution using ANUSPLIN for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: projected number of large fires (>200 ha) across Canada for the long-term (2071-2100) under the RCP 2.6 (rapid emissions reductions).Reference: Boulanger, Y., Gauthier, S., et al. 2014. A refinement of models projecting future Canadian fire regimes using homogeneous fire regime zones. Canadian Journal of Forest Research 44, 365–376.

Kernel density estimation (KDE) utilizes spatially explicit data to model the distribution of a variable of interest. It is a simple non-parametric neighbour-based smoothing function that relies on few assumptions about the structure of the observed data. It has been used in ecology to identify hotspots, that is, areas of relatively high biomass/abundance, and in 2010 was used by Fisheries and Oceans Canada to delineate significant concentrations of corals and sponges. The same approach has been used successfully in the Northwest Atlantic Fisheries Organization (NAFO) Regulatory Area. Here, we update the previous analyses with the catch records from up to 5 additional years of trawl survey data from Eastern Canada, including the Gulf of Saint Lawrence. We applied kernel density estimation to create a modelled biomass surface for each of sponges, small and large gorgonian corals, and sea pens, and applied an aerial expansion method to identify significant concentrations of these taxa. We compared our results to those obtained previously and provided maps of significant concentrations as well as point data co-ordinates for catches above the threshold values used to construct the significant area polygons. The borders of the polygons can be refined using knowledge of null catches and species distribution models of species presence/absence and/or biomass.

Terrestrial Ecosystem Mapping (TEM) Project Boundaries (STE_TEM_PROJECT_BOUNDARIES_SVW) contains boundaries (study areas) and attributes describing each TEM project (project level metadata), plus links to the locations of other data associated with the project (e.g., reports, polygon datasets, plotfiles, field data, legends). This layer is derived from the [STE_TEI_PROJECT_BOUNDARIES_SP](https://catalogue.data.gov.bc.ca/dataset/1313fac7-2ea1-4c6b-995b-bd421b7ec3c6) layer by filtering on the PROJECT_TYPE attribute. Project Types include: TEM, NEM, TEMNSS, NEMNSS, TEMPRE, NEMPRE, TEMSEI, TEMSET, TEMTSM, TEMWHR, TEMSDM, TEMPRW, NEMPRW, and NEMSEI. TEM project boundaries should be used in conjunction with TEM detailed inventory polygons which divide the landscape into units according to a variety of ecological features including climate, physiography, surficial material, bedrock geology, soils and vegetation. TEM inventory polygons with full Resources Information Standards Committee (RISC) attributes can be accessed through the [Terrestrial Ecosystem Information (TEI) Data Distribution Packages](https://catalogue.data.gov.bc.ca/dataset/8fd15e4e-e7b1-4566-81d1-1ff8947bfd46). TEM inventory polygons with simplified and amalgamated (concatenated) RISC attributes can be accessed through the [Terrestrial Ecosystem Mapping (TEM) Detailed Polygons with Short Table Attribute Table Spatial View](https://catalogue.data.gov.bc.ca/dataset/0a83163b-a62f-4ce6-a9a1-21c228b0c0a3). **Current version**: v12 (2026-06-22)

Modeled data showing the likely distribution of dall's porpoises. CRIMS is a legacy dataset of BC coastal resource data that was acquired in a systematic and synoptic manner from 1979 and was intermittently updated throughout the years. Resource information was collected in nine study areas using a peer-reviewed provincial Resource Information Standards Committee consisting of DFO Fishery Officers, First Nations, and other subject matter experts. There are currently no plans to update this legacy data.

Marine Protected Areas require comprehensive monitoring to ensure objectives are achieved; however, monitoring natural ecosystems at scale is challenged by the biodiversity it aims to measure. Environmental DNA (eDNA) metabarcoding holds promise to address this monitoring challenge. We conducted paired sampling at 54 sites for fish and invertebrate assemblages in the Northwest Atlantic using groundfish trawls and eDNA metabarcoding of benthic seawater using four genetic markers (12S rRNA, 16S rRNA, 18S rRNA, and CO1). Compared to trawling, eDNA detected similar patterns of species turnover, larger estimates of gamma diversity, and smaller estimates of alpha diversity. A total of 63.6% (42/66) of fish species captured by trawling were detected by eDNA, along with an additional 26 species. Of the 24 missed detections by eDNA, 12 were inevitable as they lacked reference sequences. Excluding taxa assigned to higher than species level and those without a species name, 23.6% (17/72) of invertebrate species captured by trawling were detected by CO1, which detected an additional 98 species. We demonstrate that eDNA is capable of detecting patterns of community assemblage and species turnover in an offshore environment, emphasizing its strong potential for a non-invasive, comprehensive, and scalable tool for biodiversity monitoring supporting marine conservation programmes.Cite this data as: Jeffery, N., Rubidge, E., Abbott, C., Westfall, K., Stanley, R. (2024): Data of: eDNA metabarcoding enriches traditional trawl survey data for monitoring biodiversity in the marine environment.Published: August 2024. Coastal Ecosystems Science Division, Fisheries and Oceans Canada, Dartmouth, N.S. https://open.canada.ca/data/en/dataset/43a91ba7-8025-4330-88db-db14022d729d

The spatial representation for a Forest Deletion, which is any Forest land that is to be removed from the land designated by the Lieutenant Governor into an established forest

Description:Seasonal mean aragonite saturation state from the British Columbia continental margin model (BCCM) were averaged over the 1981 to 2010 period to create seasonal mean climatology of the Canadian Pacific Exclusive Economic Zone.Methods:Aragonite saturation states at up to forty-six linearly interpolated vertical levels from surface to 2400 m and at the sea bottom are included. Spring months were defined as April to June, summer months were defined as July to September, fall months were defined as October to December, and winter months were defined as January to March. The data available here contain raster layers of seasonal aragonite saturation state climatology for the Canadian Pacific Exclusive Economic Zone at 3 km spatial resolution and 47 vertical levels.Uncertainties:Model results have been extensively evaluated against observations (e.g. altimetry, CTD and nutrient profiles, observed geostrophic currents), which showed the model can reproduce with reasonable accuracy the main oceanographic features of the region including salient features of the seasonal cycle and the vertical and cross-shore gradient of water properties. However, the model resolution is too coarse to allow for an adequate representation of inlets, nearshore areas, and the Strait of Georgia.

The fire regime describes the patterns of fire seasonality, frequency, size, spatial continuity, intensity, type (e.g., crown or surface fire) and severity in a particular area or ecosystem.The number of large fires refers to the annual number of fires greater than 200 hectares (ha) that occur per units of 100,000 ha. It was calculated per Homogeneous Fire Regime (HFR) zones. These HFR zones represent areas where the fire regime is similar over a broad spatial scale (Boulanger et al. 2014). Such zonation is useful in identifying areas with unusual fire regimes that would have been overlooked if fires had been aggregated according to administrative and/or ecological classifications.Fire data comes from the Canadian National Fire Database covering 1959–1999 (for HFR zones building) and 1959-1995 (for model building). Multivariate Adaptive Regression Splines (MARS) modeling was used to relate monthly fire regime attributes with monthly climatic/fire-weather in each HFR zone. Future climatic data were simulated using the Canadian Earth System Model version 2 (CanESM2) and downscaled at a 10 Km resolution using ANUSPLIN for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: the number of large fires (>200 ha) across Canada for a reference period (1981-2010).Reference: Boulanger, Y., Gauthier, S., et al. 2014. A refinement of models projecting future Canadian fire regimes using homogeneous fire regime zones. Canadian Journal of Forest Research 44, 365–376.