This map shows the location of geodetic points in Quebec. It is available in the form of an interactive map and downloadable vector files. The location of the points is based on the approximate coordinates (± two meters).The geodetic network consists of approximately 112,000 landmarks grouped under six themes:* Permanent GNSS stations;* The 3D precision network;* The planimetric network;* The altimeter network;* Points presumed destroyed or damaged;* Destroyed points.The vector product contains the following information:* The original number;* The service number;* The state of the geodesic point;* The theme to which it belongs.The ** [interactive map] (https://geodesie.portailcartographique.gouv.qc.ca/) ** offers more information and provides access to the associated data sheet.# #Bases calibration for electronic rangefinderTo allow rapid and effective control of distance measuring instruments (electronic telemeter), a network of permanent calibration bases has been established in the main regions of Quebec.Information relating to each of the bases, including inter-pillar distances, can be obtained by clicking below on the name of the municipality where the base is located:* [Chambly] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Chambly.pdf)* [Mont-Joli] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Mont-Joli.pdf)* [Neuville] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Neuville.pdf)* [Port Cartier] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Port-Cartier.pdf)* [Saguenay] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Saguenay.pdf)* [Terrebonne] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Terrebonne.pdf): the calibration base no longer exists* [Trois-Rivières] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Trois-Rivieres.pdf)* [Val-d'Or] (https://diffusion.mern.gouv.qc.ca/diffusion/RGQ/Documentation/Geodesie/Bases_Etalonnage/Val_d_Or.pdf)**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

A magnitude 5 earthquake scenario along an unnamed fault located about 15 km north-northeast of Burnaby City Hall and directly south of Mt Elsay. This fault is not known to be active, but this scenario represents a small but damaging event in the North Shore Mountains.

This dataset contains observations of species occurrences from seafloor imagery collected by the autonomous underwater vehicle (AUV) during the 2012 Expedition to Cobb Seamount. The National Oceanographic and Atmospheric Administration-operated SeaBED-class AUV which collected photographic images from 4 transects ranging from 436 m to 1154 m in depth.

This dataset contains observations of species occurrences from seafloor imagery collected by the remotely operated underwater vehicle (ROV) during the 2012 Expedition to Cobb Seamount. The ROV operated by Fisheries and Oceans Canada was a customized Deep Ocean Engineering Phantom HD2+2 which collected photographic images from 12 transects ranging from 35 m to 211 m in depth.

The spatial representation for a polygon defining the area of the province defined as west of the Cascade Mountains

Terrestrial Ecosystem Mapping for Mt Broadwood Heritage Conservation Area in the Rocky Mountain Forest District (ttem_bd)

Toponymic Features entity is Named Feature (geographical name or toponym). CanVec is a digital cartographic reference product of Natural Resources Canada (NRCan). It originates from the best available data sources covering Canadian territory, offers quality topographical information in vector format, and complies with international geomatics standards. CanVec is a multi-source product coming mainly from the National Topographic Data Base (NTDB), the Mapping the North process conducted by the Canada Center for Mapping and Earth Observation (CCMEO), the Atlas of Canada data, the GeoBase initiative, and the data update using satellite imagery coverage (e.g. Landsat 7, Spot, Radarsat, etc.).Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@gov.yk. ca](mailto:geomatics.help@yukon.ca)

The dataset represents known concentration areas of harvested or unharvested Atlantic surfclam (Spisula solidissima) in the Gulf of St. Lawrence, around the Magdalen Islands. The dataset was created for the National environmental emergencies center (NEEC) for preparation and response in case of an oil spill. Concentration areas were delineated using Fisheries and Oceans Canada (DFO) inventories conducted between 2000 and 2020, commercial fisheries data (logbooks and purchase receipts from 2002 to 2020 and observations at sea from 2005 to 2017), data from exploratory fisheries as well as interviews.This layer is dependent on the inventories carried out and thus only represents the known areas of the Atlantic surfclam. This dataset does not represent the general distribution of the species nor the extent to which fishing is allowed. Most of the information comes from inventories that did not necessarily target this species, therefore its distribution is undoubtedly wider than what is recorded in this layer. In addition, the extent of shellfish beds can change over time in response to, among others, harvesting and recruitment rates. Some concentration areas were delimited based on interviews with people who locally know the resource but their delimitation remains approximate. The polygons delimited based on sampling data are more precise but might underestimate the concentration areas because sampling was made where the target resource was known to be more abundant without necessarily sampling the entire bed. Nonetheless, the precision is sufficient for resource protection and management needs in case of an environmental incident.Data sources and references:Bio-Conseil. 1986. Pêche exploratoire à la palourde (Spisula solidissima) aux Îles-de-la-Madeleine, automne 1985. Rapport final, Bio-Conseil, Pêches et Océans Canada. 24 p.Bernier, L. and L. Poirier. 1979. Evaluation sommaire du stock de mactres de l'Atlantique, Spisula solidissima Dillwyn, des Îles-de-la-Madeleine (golfe du St-Laurent). Cahier d'information, ministère de l'Industrie et du Commerce. 42 p.Bourget, E. and D. Messier. 1983. Macrobenthic density, biomass, and fauna of intertidal and subtidal sand in a Magdalen Islands lagoon, Gulf of St. Lawrence. Can. J. Zool. 61(11):2509-2518.Brulotte, S. 2013. Évaluation des stocks de la mactre de l’Atlantique, Spisula solidissima, des eaux côtières des Îles-de-la-Madeleine – méthodologies et résultats. Secr. can. de consult. sci. du MPO. Doc. de rech. 2013/082: x + 58 p.Brulotte, S. 2016. Évaluation des stocks de mactre de l’Atlantique, Spisula solidissima, des Îles-de-la-Madeleine, Québec en 2015 – méthodologie et résultats. Secr. can. de consult. sci. du MPO. Doc. de rech. 2016/074. x + 51 p.DFO. 2016. Stock Assessment of Atlantic Surfclam of the Îles-de-la-Madeleine in 2015. DFO Can. Sci. Advis. Sec. Sci. Advis. Rep. 2016/022.DFO. 2019. Assessment of the Îles-de-la-Madeleine Atlantic Surfclam stock in 2018. DFO Can. Sci. Advis. Sec. Sci. Advis. Rep. 2019/031.Fréchette, M. and M. Giguère. 1984. Rapport sur une pêche exploratoire à la palourde aux Îles-de-la-Madeleine en 1984. Pêches et Océans Canada. 17 p.Hurlbut, T and D. Clay. 1990. Protocols for research vessel cruises within the Gulf region (demersal fish) (1970-1987). Can. Manuscr. Rep. Fish. Aquat. Sci. 2082:143p.Hurtubise, S. (Fisheries Data [ZIFF] and At-Sea Observers Manager). Unpublished data. Fisheries and Oceans Canada.

Toponymic Features entity is Named Feature (geographical name or toponym). CanVec is a digital cartographic reference product of Natural Resources Canada (NRCan). It originates from the best available data sources covering Canadian territory, offers quality topographical information in vector format, and complies with international geomatics standards. CanVec is a multi-source product coming mainly from the National Topographic Data Base (NTDB), the Mapping the North process conducted by the Canada Center for Mapping and Earth Observation (CCMEO), the Atlas of Canada data, the GeoBase initiative, and the data update using satellite imagery coverage (e.g. Landsat 7, Spot, Radarsat, etc.).Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Toponymic Features entity is Named Feature (geographical name or toponym). CanVec is a digital cartographic reference product of Natural Resources Canada (NRCan). It originates from the best available data sources covering Canadian territory, offers quality topographical information in vector format, and complies with international geomatics standards. CanVec is a multi-source product coming mainly from the National Topographic Data Base (NTDB), the Mapping the North process conducted by the Canada Center for Mapping and Earth Observation (CCMEO), the Atlas of Canada data, the GeoBase initiative, and the data update using satellite imagery coverage (e.g. Landsat 7, Spot, Radarsat, etc.).Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)