Fire management zones help guide how wildfires are prioritized and managed and show where wildfires may be used to achieve ecological objectives. Zones are based on relatively constant factors, such as the level of human use or development and the presence of reliable fuel breaks.Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Map of burned area in Canada's forested ecosystems for the 2023 fire session at 30-m spatial resolution mapped from time-series data from Sentinel-2A and -2B, and Landsat-8 and -9 using the Tracking Intra- and Inter-year Change (TIIC) algorithm (Pelletier et al. 2024). It is developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS). Fires are grouped into two classes based on detection period: summer fires and fall fires. Summer burned pixels were detected between May 30 and September 17, and fall burned pixels were detected between September 17 and October 25. For summer fires, burned pixels were identified by TIIC as changed and typed as fire. For the fall period, TIIC only detected changes within a 4-km buffer of the NRCan fire perimeters (https://cwfis.cfs.nrcan.gc.ca/datamart). This approach was used to limit commission errors that can occur due to known limitations of mapping with optical data in the fall due to phenology, snow cover, or low sun angles. For the 2023 fire season, the TIIC algorithm detected 12.74 Mha of burned area in Canada's forested ecozones, representing 1.8% of the total forest-dominated ecozone area. Of the 12.74 Mha, 11.57 Mha (90.9%) was burned by summer fires and 1.16 Mha (9.1%) by fall fires (Pelletier et al, 2024).When using this data, please cite as: Pelletier, F., Cardille, J.A., Wulder, M.A., White, J.C., Hermosilla, T., 2024. Revisiting the 2023 wildfire season in Canada. Science of Remote Sensing. 10, 100145. (Pelletier et al. 2024).

The Regional Air Quality Deterministic Prediction System FireWork (RAQDPS-FW) carries out physics and chemistry calculations, including emissions from active wildfires, to arrive at deterministic predictions of chemical species concentration of interest to air quality, such as fine particulate matter PM2.5 (2.5 micrometers in diameter or less). Geographical coverage is Canada and the United States. Data is available at a horizontal resolution of 10 km. While the system encompasses more than 80 vertical levels, data is available only for the surface level. The products are presented as historical, annual or monthly, averages which highlight long-term trends in cumulative effects on the environment.

Hotspots represent active wildfires. Natural Resources Canada Canadian Wild Fire Information System identifies them by processing Infrared satellite images. This layer contains the hotspots that are selected to be used as input for the Regional Air Quality Deterministic Prediction System FireWork (RAQDPS-FW) to enable forecasting air quality while taking into account wildfire emissions. Geographical coverage is Canada and the United States. The products are presented as historical annual compilations which highlight long-term trends in cumulative effects on the environment.

Wildfire Year/dNBR/Mask 1985-2015Wildfire change magnitude 85-15. Spectral change magnitude for wildfires that occurred from 1985 and 2015. It is developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS). The wildfire change magnitude included in this product is expressed via differenced Normalized Burn Ratio (dNBR), computed as the variation between the spectral values before and after the change event. This dataset is composed of three layers: (1) binary wildfire mask, (2) year of greatest wildfire disturbance, and (3) differenced Normalized Burn Ratio (dNBR) transformed for data storage efficiency to the range 0-200. The actual dNBR value is derived as follows: dNBR = value / 100. Higher dNBR values are related to higher burn severity. The information outcomes represent 30 years of wildfires in Canada's forests, derived from a single, consistent spatially-explicit data source in a fully automated manner. Time series of Landsat data with 30-m spatial resolution were used to characterize national trends in stand replacing forest disturbances caused by wildfire for the period 1985-2015 for Canada's 650 million hectare forested ecosystems.When using this data, please cite as: Hermosilla, T., M.A. Wulder, J.C. White, N.C. Coops, G.W. Hobart, L.B. Campbell, 2016. Mass data processing of time series Landsat imagery: pixels to data products for forest monitoring. International Journal of Digital Earth 9(11), 1035-1054. (Hermosilla et al. 2016).See references below for an overview on the data processing, metric calculation, change attribution and time series change detection methods applied, as well as information on independent accuracy assessment of the data.Hermosilla, T., Wulder, M. A., White, J. C., Coops, N.C., Hobart, G.W., 2015. An integrated Landsat time series protocol for change detection and generation of annual gap-free surface reflectance composites. Remote Sensing of Environment 158, 220-234. (Hermosilla et al. 2015a).Hermosilla, T., Wulder, M.A., White, J.C., Coops, N.C., Hobart, G.W., 2015. Regional detection, characterization, and attribution of annual forest change from 1984 to 2012 using Landsat-derived time-series metrics. Remote Sensing of Environment 170, 121-132. (Hermosilla et al. 2015b).Geographic extent: Canada's forested ecosystems (~ 650 Mha)Time period: 1985–2011

Dataset including information on wildfires in the province of Alberta from 2006 to 2025, inclusive. Information tracked for each fire includes: cause, size, location (latitude and longitude, legal land description, and forest area), time and duration, weather conditions, staffing and physical resources used to suppress the fire, and area burned.

Dataset including information on wildfires in the province of Alberta from 1996 to 2005, inclusive. Information tracked for each fire includes: cause, size, location (latitude and longitude, legal land description, and forest area), time and duration, weather conditions, staffing and physical resources used to suppress the fire, and area burned.

Wildfire change magnitude 1985-2022. Spectral change magnitude for wildfires that occurred from 1985 to 2022. It is developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS). The wildfire change magnitude included in this product is expressed via differenced Normalized Burn Ratio (dNBR), computed as the variation between the spectral values before and after a given change event. Higher dNBR values are related to higher burn severity. Time series of Landsat data with 30-m spatial resolution were used to characterize national trends in stand replacing forest disturbances caused by wildfire for the period 1985-2022 for Canada's 650 million-hectare forested ecosystems.When using this data, please cite as: Hermosilla, T., M.A. Wulder, J.C. White, N.C. Coops, G.W. Hobart, L.B. Campbell, 2016. Mass data processing of time series Landsat imagery: pixels to data products for forest monitoring. International Journal of Digital Earth 9(11), 1035-1054. (Hermosilla et al. 2016).See references below for an overview on the data processing, metric calculation, change attribution and time series change detection methods applied, as well as information on independent accuracy assessment of the data.Hermosilla, T., Wulder, M. A., White, J. C., Coops, N.C., Hobart, G.W., 2015. An integrated Landsat time series protocol for change detection and generation of annual gap-free surface reflectance composites. Remote Sensing of Environment 158, 220-234. (Hermosilla et al. 2015a).Hermosilla, T., Wulder, M.A., White, J.C., Coops, N.C., Hobart, G.W., 2015. Regional detection, characterization, and attribution of annual forest change from 1984 to 2012 using Landsat-derived time-series metrics. Remote Sensing of Environment 170, 121-132. (Hermosilla et al. 2015b).

Dataset including information on wildfires in the province of Alberta from 1961 to 1982, inclusive. Information tracked for each fire includes: cause, size, location (latitude and longitude, legal land description, and forest area), time and duration, weather conditions, staffing and physical resources used to suppress the fire, and area burned.

Dataset including information on wildfires in the province of Alberta from 1983 to 1995, inclusive. Information tracked for each fire includes: cause, size, location (latitude and longitude, legal land description, and forest area), time and duration, weather conditions, staffing and physical resources used to suppress the fire, and area burned.