Routes that cruise ships travel off the coast of BC

All fundamental watershed polygons generated from watershed boundary lines, bank edges, delimiter edges, coastline edges, and administrative boundary edges

Flow network arcs (observed, inferred and constructed). Contains no banks, coast or watershed bourdary arcs. Directionalized and connected. Contains heirarchial key and route identifier

The Coastal Infrastructure Vulnerability Index (CIVI) was jointly developed by DFO Science Branch, Small Craft Harbours (SCH) Program and the Economic Analysis and Statistics Directorate. The CIVI was designed with the intent of developing a climate change adaptation tool that would support management decisions regarding the long-term infrastructure planning for SCH sites.The CIVI provides a numerical indication of the relative vulnerability of small craft harbour sites to the effects of climate change and was designed with three component sub-indices: Environmental Exposure (natural forces), Infrastructure, and Socio-economic. The spatial component for the coastline was derived from the CanVec 1:50,000 hydrographic layer (https://open.canada.ca/data/en/dataset/9d96e8c9-22fe-4ad2-b5e8-94a6991b744b).This layer combines the 1:50,000 CanVec coastline of Canada with the following CIVI environmental exposure variables:- projected sea level rise (for the decades 2030, 2040,...2100) in meters- wave height (metres) and wind speed (metres/second)- change in sea ice coverage in Atlantic Canada from the 1970s to the 2000sSea level change:Data for relative sea level change (SLC) were derived from the Intergovernmental Panel on Climate Change Fifth Assessment Report (IPCC 2014, AR5). The projected relative sea level change under the high emission scenario (RCP8.5) was calculated for all years between 2006 and 2100. Sea level change for the years 2030, 2040, 2050, 2060, 2070, 2080, 2090, and 2100 were used.Wind Speed and Wave HeightModelled hindcasts of yearly maximum wind speed (1990 - 2012) and wave height (1990- 2014) were used. This dataset was generated from IFREMER wave hindcasts using the WAVEWATCH III model with wind data from NCEP Climate Forecast System Reanalysis (CFSR) (Saha et al. 2010). Two high resolution (10 minute) grids of Atlantic and Pacific maximum modeled wind speeds and maximum significant wave height were used for southern Canadian coastal areas while a coarser (30 minute) worldwide grid was used for the Arctic areas. From these datasets the mean annual maximum wind speed over 23 years and the mean maximum significant wave height over 25 years were calculated.Change in sea ice coverage:Sea ice data from the Canadian Ice Service were acquired for Atlantic and Arctic Canada, representing percent ice coverage for each week over four decades (1970s, 1980s, 1990, 2000s). For each decade a single dataset was calculated to represent the sum of all weeks with ice coverage in excess of 50%, with a maximum possible score of 52 weeks for each decade. To measure change in ice duration, the summary mapsheet from the 2000s was subtracted from the 1970s summary mapsheet. The final dataset represents the change between the 1970s and 2000s in the number of weeks with ice concentrations greater than 50%. A positive number indicates a reduction in weeks of ice coverage, a negative number an increase in ice coverage.The data for individual small craft harbours included here contains predicted sea level change for the decades between 2030 and 2100, wave height, windspeed, change in sea ice coverage, population, and the final environmental exposure sub-index value (ESI). The population for each harbour is derived from the 2016 Census of Canada data for the Census subdivision (CSD) geographic unit.Reference:Relative sea-level projections for Canada based on the IPCC Fifth Assessment Report and the NAD83v70VG national crustal velocity modelhttps://doi.org/10.4095/327878 IPCC, 2014. Climate Change 2014: Impacts, Adaptation, and Vulnerability. Part A: Global and Sectoral Aspects. Contribution of Working Group II to the Fifth Assessment Report of the Intergovernmental Panel on Climate Change [Field, C.B., V.R. Barros, D.J. Dokken, K.J. Mach, M.D. Mastrandrea, T.E. Bilir, M. Chatterjee, K.L. Ebi, Y.O. Estrada, R.C. Genova, B. Girma, E.S. Kissel, A.N. Levy, S. MacCracken, P.R. Mastrandrea, and L.L. White (eds.)]. Cambridge University Press, Cambridge, United Kingdom and New York, NY, USA, 1132 pp.Cite this data as: Greenan B. and Greyson P. Coastal Environmental Exposure Layer. Published March 2022. Ocean Ecosystem Science Division, Fisheries and Oceans Canada, Dartmouth, N.S.

This layer represents important areas for the Harp seal (Pagophilus groenlandicus). It includes the three main pupping areas for this species and migratory pathways used by Harp seals to migrate between its summering (Baffin Bay) and wintering (Gulf of St. Lawrence and Newfoundland and Labrador coasts) areas. Note that this dataset do not represent the Harp seal distribution.Reference:DFO. 2020. 2019 Status of Northwest Atlantic Harp Seals, Pagophilus groenlandicus. DFO Can. Sci. Advis. Sec. Sci. Advis. Rep. 2020/020.

The marks left in the seabed by the commercial anchoring process can be seen as linear features in high-resolution multibeam bathymetry data. These features have been digitized to polylines for individual marks and polygons for anchor scour zones for British Columbia's (BC) commercial anchorages. They are made available via the Federal Geospatial Platform (FGP) for use in a Geographical Information System (GIS). This feature dataset is complete for published BC commercial anchorages and the multibeam bathymetry data available in 2021. It does not represent features produced since the collection of each multibeam bathymetry survey nor any features infilled since. The data are intended to be used for scientific research to better understand the cumulative impacts to the seabed from commercial anchoring at a 1:5000 scale or greater.

The Beaufort Sea and Mackenzie Delta dataset comes from the Petroleum and Environmental Management Tool (PEMT). The online tool was decommissioned in 2019 and the data was transferred to Open Data in order to preserve it.The PEMT was originally developed in 2009 to help guide development in the Canadian Arctic by Indian and Northern Affairs Canada (INAC). The online tool mapped the sensitivities of a variety of Arctic features, ranging from whales to traditional harvesting, across the Arctic. The tool was intended to aid government, oil and gas companies, Aboriginal groups, resource managers and public stakeholders in better understanding the geographic distribution of areas which are sensitive for environmental and socio-economic reasons. The study area and analytical resolution was defined using the oil and gas leasing grid within the Beaufort Sea. The study area has been the scene of oil and gas exploration activity since 1957. Oil was first discovered at Atkinson Point in 1969 and major gas fields in the early 1970s. Such finds spurred the proposal of the Mackenzie Valley Pipeline in 1974 and the addition of exploration and investment offshore. Exploration and drilling continued both onshore and offshore until the mid-1970s with the release of the Berger Report, which recommended a 10-year moratorium on the construction of the pipeline. After the release of the Berger Report, the pace of onshore activity declined but offshore exploration escalated in the 1980s. Offshore exploration was facilitated with innovative operating techniques and new offshore platforms that extended the ability to operate in the short open-water season and ice. With the minor exception of the small onshore gas field at Ikhil, no oil or gas has been commercially produced in the area.DISCLAIMER: Please refer to the PEMT Disclaimer document or the Resource Constraints - Use Limitation in the Additional Information section below.Note: This is one of the 3 (three) datasets included in the PEMT application which includes the High Arctic and Eastern Arctic datasets.

Benthic Marine Ecounits in coastal and offshore British Columbia. Benthic ecounits are intended to describe the sea bed and nearshore. Seven variables were selected to derive benthic ecounits: 1. Depth; 2. Slope; 3. Relief; 4. Temperature; 5. Exposure; 6. Current and 7. Substrate. CRIMS is a legacy dataset of BC coastal resource data that was acquired in a systematic and synoptic manner from 1979 and was intermittently updated throughout the years. Resource information was collected in nine study areas using a peer-reviewed provincial Resource Information Standards Committee consisting of DFO Fishery Officers, First Nations, and other subject matter experts. There are currently no plans to update this legacy data.

This line outlines the basic survey route included in the survey counts. This route is the best access to areas that can be surveyed from shore.

Yukon Oil and Gas Rights Disposition Process. Call for Bids (CFB) - an invitation to submit bids for posted locations. The Call for Bids dataset contains basic information on disposition process administered by Yukon Government. For more information on disposition process visit [https://yukon.ca/en/doing-business/licensing/apply-oil-and-gas-rights#disposition-overview](https://yukon.ca/en/doing-business/licensing/apply-oil-and-gas-rights)Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)