This dataset contains the modelled and observed data used in the publication "Fjord circulation permits persistent subsurface water mass in a long, deep mid-latitude inlet" by Laura Bianucci et al., DFO Ocean Sciences Division, Pacific Region (published in the journal Ocean Science in 2024). An application of the Finite Volume Community Ocean Model (FVCOM v4.1) was run from May 24 to June 27, 2019 in the Discovery Islands region of British Columbia, Canada. Observed temperature and salinity profiles available in this area during this time period are included in the dataset, along with the modelled values at the same times and locations.

This dataset contains the outputs for Bute Inlet from two simulations shown in the publication "Fjord circulation permits persistent subsurface water mass in a long, deep mid-latitude inlet" by Laura Bianucci et al., DFO Ocean Sciences Division, Pacific Region (published in the journal Ocean Science in 2024). The Finite Volume Community Ocean Model (FVCOM v4.1) was run with two different sets of initial conditions for the Discovery Islands region of British Columbia, Canada, from May 24 to June 27, 2019. The "Baseline" simulation used observed initial conditions, while the "Sensitivity" simulation removed the observed cold subsurface water mass from the initial profiles. Here in this dataset, we provide 29-day averages of the following variables in a transect along Bute Inlet: potential temperature, density, along-inlet velocity, and Brunt-Väisälä frequency (N^2). The averaging properly removes the tidal effects.

These are derived products of ocean bottom temperature at St. Anns Bank Marine Protected Area (MPA), utilizing outputs from two numerical models: 1) Pseudo-analysis from the Coastal Ice-Ocean Prediction System for the East Coast of Canada (CIOPS-E v2.0.0) at 1/36° horizontal grid developed and implemented operationally at Environment and Climate Change Canada, covering 2016-2023 through combining research and operational runs from this system (https://eccc-msc.github.io/open-data/msc-data/nwp_ciops/readme_ciops_en/); 2) The Global Ocean Physics Reanalysis (GLORYS12v1), a 1/12° data assimilative reanalysis product produced by the Mercator Ocean International and implemented by the CMEMS, spanning from 1993 to 2023 ( https://doi.org/10.48670/moi-00021). The daily bottom temperature data presented here are calculated as daily area averages. The ocean bottom temperature data from the model available here are validated against in-situ observations from the open data (https://open.canada.ca/data/en/dataset/910b8e22-2fd1-4ba1-8db6-d16763c7a625). These products may be used to gain knowledge of ocean bottom temperature changes in the MPA over the past 8 and 30 years.Cite this data as: Casey, M., Hu, X, Tao, J., and Shen, H. Ocean Bottom Temperature Variations from CIOPS-E and GLORYS12 Models at St. Anns Bank. Published: August 2024. Ecosystems and Oceans Science, Maritimes region, Fisheries and Oceans Canada, Dartmouth NS. https://open.canada.ca/data/en/dataset/019f9138-6e3c-4f0e-997e-879e1ec2c42d

This dataset provides 1/36-degree monthly-mean ocean current climatology (April - September) in the Northeast Pacific. The climatological fields are derived from hourly ocean currents for the period from 1993 to 2020, simulated using a high-resolution Northeast Pacific Ocean Model (NEPOM).

This dataset provides 1/36-degree monthly mean ocean current climatology (October - March) in the Northeast Pacific. The climatological fields are derived from hourly ocean currents for the perid from 1993 to 2020, simulated using a high-resolution Northeast Pacific Ocean Model (NEPOM).

The Coastal Ice Ocean Prediction System (CIOPS) provides a 48 hour ocean and ice forecast over different domains (East, West, Salish Sea) four times a day at 1/36° resolution. A pseudo-analysis component is forced at the ocean boundaries by the Regional Ice Ocean Prediction System (RIOPS) forecasts and spectrally nudged to the RIOPS solution in the deep ocean. Fields from the pseudo-analysis are used to initialize the 00Z forecast, whilst the 06, 12 and 18Z forecasts use a restart files saved at hour 6 from the previous forecast. The atmospheric fluxes for both the pseudo-analysis and forecast components are provided by the High Resolution Deterministic Prediction System (HRDPS) blended both spatially and temporally with either the Global Deterministic Prediction System (GDPS) (for CIOPS-East) or an uncoupled component of the Global Deterministic Prediction System (GDPS) at 10km horizontal resolution (for CIOPS-West) for areas not covered by the HRDPS.

Monthly mean currents from Bedford Institute of Oceanography North Atlantic Model (BNAM) results were averaged over 1990 to 2015 period to create monthly mean climatology for the Northwest Atlantic Ocean, which can be considered as a representation of the climatological state of the Northwest Atlantic Ocean. The BNAM model is eddy-resolving, NEMO-based ice-ocean coupled North Atlantic Ocean model developed at the Bedford Institute of Oceanography (BIO) to support DFO monitoring programs. The data available here is monthly climatology for eight selected depths (surface, 110 m, 156 m, 222 m, 318 m, 541 m, 1062 m, bottom) in 1/12 degree spatial resolution. The data for each month from 1990 until present for the entire model domain ( 8°–75°N latitude and 100°W–30°E longitude) and various depths is available upon request.The 1990-2017 model hindcast result is compared with observational data from surface drifter and satellite altimetry. The model demonstrates good skill in simulating surface currents, winter convection events in the Labrador Sea, and the Atlantic Meridional Overturning Circulation as observed at 26.5°N and 41°N. Model results have been used to interpret changes in the Labrador Current and observed warming events on the Scotian Shelf, and are reported through the annual AZMP Canadian Science Advisory Secretariat Process.When using data please cite following:Wang, Z., Lu, Y., Greenan, B., Brickman, D., and DeTracey, B., 2018. BNAM: An eddy resolving North Atlantic Ocean model to support ocean monitoring. Can. Tech. Rep. Hydrogr. Ocean. Sci. 327: vii + 18p

Monthly mean salinity from Bedford Institute of Oceanography North Atlantic Model (BNAM) results were averaged over 1990 to 2015 period to create monthly mean climatology for the Northwest Atlantic Ocean, which can be considered as a representation of the climatological state of the Northwest Atlantic Ocean. The BNAM model is eddy-resolving, NEMO-based ice-ocean coupled North Atlantic Ocean model developed at the Bedford Institute of Oceanography (BIO) to support DFO monitoring programs. The data available here is monthly climatology for eight selected depths (surface, 110 m, 156 m, 222 m, 318 m, 541 m, 1062 m, bottom) in 1/12 degree spatial resolution. The data for each month from 1990 until present for the entire model domain ( 8°–75°N latitude and 100°W–30°E longitude) and various depths is available upon request.The 1990-2017 model hindcast result is compared with observational data from surface drifter and satellite altimetry. The model demonstrates good skill in simulating surface currents, winter convection events in the Labrador Sea, and the Atlantic Meridional Overturning Circulation as observed at 26.5°N and 41°N. Model results have been used to interpret changes in the Labrador Current and observed warming events on the Scotian Shelf, and are reported through the annual AZMP Canadian Science Advisory Secretariat Process.When using data please cite following:Wang, Z., Lu, Y., Greenan, B., Brickman, D., and DeTracey, B., 2018. BNAM: An eddy resolving North Atlantic Ocean model to support ocean monitoring. Can. Tech. Rep. Hydrogr. Ocean. Sci. 327: vii + 18p

Monthly mean temperature from Bedford Institute of Oceanography North Atlantic Model (BNAM) results were averaged over 1990 to 2015 period to create monthly mean climatology for the Northwest Atlantic Ocean, which can be considered as a representation of the climatological state of the Northwest Atlantic Ocean. The BNAM model is eddy-resolving, NEMO-based ice-ocean coupled North Atlantic Ocean model developed at the Bedford Institute of Oceanography (BIO) to support DFO monitoring programs. The data available here is monthly climatology for eight selected depths (surface, 110 m, 156 m, 222 m, 318 m, 541 m, 1062 m, bottom) in 1/12 degree spatial resolution. The data for each month from 1990 until present for the entire model domain ( 8°–75°N latitude and 100°W–30°E longitude) and various depths is available upon request.The 1990-2017 model hindcast result is compared with observational data from surface drifter and satellite altimetry. The model demonstrates good skill in simulating surface currents, winter convection events in the Labrador Sea, and the Atlantic Meridional Overturning Circulation as observed at 26.5°N and 41°N. Model results have been used to interpret changes in the Labrador Current and observed warming events on the Scotian Shelf, and are reported through the annual AZMP Canadian Science Advisory Secretariat Process.When using data please cite following:Wang, Z., Lu, Y., Greenan, B., Brickman, D., and DeTracey, B., 2018. BNAM: An eddy resolving North Atlantic Ocean model to support ocean monitoring. Can. Tech. Rep. Hydrogr. Ocean. Sci. 327: vii + 18p

Multi-model ensembles for a suite of ocean variables based on projections from Coupled Model Intercomparison Project Phase 6 (CMIP6) global climate models (GCMs) are available for 1900-2100 on a common 1x1 degree global grid. All ocean variables currently available contain data for the top level (sea surface) of the ocean.Climate projections vary across GCMs due to differences in the representation and approximation of earth systems and processes, and natural variability and uncertainty regarding future climate drivers. Thus, there is no single best climate model. Rather, using results from an ensemble of models (e.g., taking the average) is best practice, as an ensemble takes model uncertainty into account and provides more reliable climate projections.Provided on CCDS are multi-model ensembles as well as individual model simulations. Multi-model output is available for historical simulations and six Shared Socioeconomic Pathways (SSPs) (SSP1-1.9, SSP1-2.6, SSP2-4.5, SSP3-7.0, SSP4-6.0, and SSP5-8.5), four future periods (near-term (2021-2040), mid-term (2041-2060 and 2061-2080), end of century (2081-2100), and up to eight percentiles (maximum, minimum, mean, 5th, 25th, 50th (median), 75th, and 95th) of the CMIP6 ensemble distribution. Datasets are available as both actual and anomaly values. Anomalies of projected changes are expressed with respect to a historical reference period of 1995-2014. The number of models in each ensemble differs according to model availability for each SSP and variable, see the model list resource for details on the models included in each ensemble. For more information on the CMIP6 multi-model ocean datasets, see the technical documentation resource.