Fisheries and Oceans Canada has conducted a cumulative human impact mapping analysis for Pacific Canada to support ongoing Marine Spatial Planning. Cumulative impact mapping (CIM) combines spatial information on human activities, habitats, and a matrix of vulnerability weights into an intuitive relative ‘cumulative impact score’ that shows where cumulative human impacts are greatest and least. To map cumulative impacts, a recently developed ecosystem vulnerability assessment for Pacific Canadian waters (Murray et al. 2022) was combined with spatial information on thirty-eight (38) different habitat types and forty-five (45) human activities following the methodology from Halpern et al.(2008) and Murray et al. (2015). The cumulative impact map is provided in a 1x1 km grid used for oceans management by Fisheries and Oceans Canada. For further information, please contact the data provider.

A literature review, focusing on oil sand products (e.g., diluted bitumen), diluents, spill-treating agents, and crude oil toxicology and ecological studies, relevant to the northeast Pacific was compiled as part of the Government of Canada’s World Class Tanker Safety program. Of the 763 references identified, 14 involved diluted bitumen and other heavy crude oils, indicating the need for further research of these products in the marine environment. Diluent research suggests relatively fast evaporation and dispersion times for this component, however high toxicities may pose a threat to marine biota. Historical studies indicate older dispersant formulations had potential ecological implications, therefore newer formulations, which have not been studied in detail, require full assessment. Consistent utilization of toxicology standards remains elusive, hindering species sensitivity analyses. Exxon Valdez literature demonstrates highly variable impacts from a single oil type and the need for baseline data, recovery status, and suitable ecological end-point determination.

DFO Maritimes Region has conducted a cumulative human impact mapping analysis for the Scotian Shelf-Bay of Fundy management area to support ongoing Marine Spatial Planning initiatives (Murphy et al. 2024). Cumulative human impact mapping (CIM) combines spatial information on human activities and habitats with a matrix of vulnerability weights, into an intuitive relative ‘cumulative impact score’ that shows where cumulative human impacts are greatest and least. To map cumulative impacts in DFO’s Maritimes Region, a recently developed ecosystem vulnerability assessment for Atlantic Canadian waters (Murray et al. 2022) was combined with spatial information on 21 different habitat types and 45 human activities across five different sectors (climate change, land-based, marine-based, coastal, commercial fishing) following the methodology from Halpern et al. (2008). An uncertainty analysis of the cumulative impact map was conducted to assess the robustness of results and identify hot and cold spots of cumulative impacts. This dataset provides: 1) cumulative impact maps for the DFO Maritimes Region at 1 km2 resolution: a total cumulative impact map (i.e. including all 45 human activities), as well as cumulative impact maps for each of the five sectors, 2) a layer that identifies which grid cells are considered hot and cold spots of cumulative human impacts, and 3) the habitat layers included in the CIM.For further information concerning specifics of the maps and methods see Murphy et al. (2024) or contact the data provider. References:Halpern, B.S., Walbridge, S., Selkoe, K.A., Kappel, C.V., Micheli, F., D'Agrosa, C., Bruno, J.F., Casey, K.S., Ebert, C., Fox, H.E., Fujita, R., Heinemann, D., Lenihan, H.S., Madin, E.M.P., Perry, M.T., Selig, E.R., Spalding, M., Steneck, R., and Watson, R. 2008. A Global Map of Human Impact on Marine Ecosystems. Science. 319(5865): 948-952. doi:10.1126/science.1149345.Murray, C.C., Kelly, N.E., Nelson, J.C., Murphy, G.E.P., and Agbayani, S. 2022. Cumulative impact mapping and vulnerability of Canadian marine ecosystems to anthropogenic activities and stressors. DFO Can. Sci. Advis. Sec. Res. Doc. 2022/XXX. vi. + 52 p.Murphy, G.E.P., Stock, A., and Kelly, N.E. 2024 (in press). From land to deep sea: A continuum of cumulative human impacts on marine habitats in Atlantic Canada. Ecosphere.Cite this data as: Murphy, Grace; Kelly, Noreen (2023) Cumulative human impact maps for the Bay of Fundy and Scotian Shelf. Published September 2023. Coastal Ecosystems Science Division, Fisheries and Oceans Canada, Dartmouth, N.S. https://open.canada.ca/data/en/dataset/37b59b8b-1c1c-4869-802f-c09571cc984b

The Drought Impact Label dataset is used on all drought polygons from D1 to D4 to specify the longitude and magnitude of impacts. Impact labels are often used in association with the Drought Impact Line dataset.The impact labels are classified as follows:S – Short-Term, typically less than 6 months.L – Long-Term, typically more than 6 months.SL – A combination of Short and Long-Term impacts.

Drainage basins of Manitoba.Hydrologic drainage basins found within Manitoba. The Assiniboine River basin is divided to indicate the Shellmouth Reservoir subbasin, to better illustrate local impacts and conditions. Basin names are in English and French. 

The Placer Mining Land Use Regulations consist of a classification system based on varying levels of specific activities. These threshold levels categorize exploration activities into four classes of operation. Classes 1 through 4 represent activities with increasing potential to cause adverse environmental impacts.Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Zebra Mussel (Dreissena polymorpha) and Quagga Mussel (Dreissena rostriformis bugensis) have a long history of invasion in European and North American freshwater ecosystems, with significant ecological and economic impacts. An ecological risk assessment for these two invasive species for freshwater ecosystems in Canada was completed in April 2022 with the aim to provide science-based guidance to inform management decisions and actions. These include early detection, response planning, and/or regulatory and policy measures aimed at mitigating the potential spread and risk posed by Zebra and Quagga Mussels to Canadian freshwater ecosystems (DFO 2023). The Potential for Introduction (propagule pressure and connectivity), the Potential for Establishment (habitat suitability, including a Calcium-based and Maximum Entropy (MaxEnt)-based model), the Potential for Invasion, and the Ecological Impacts were used to derive Ecological Risk for Zebra and Quagga Mussels in Canada. This assessment did not evaluate the risk to individual waterbodies but rather was conducted at a 9,260 m x 9,260 m grid cell resolution. These high resolution maps are provided here. Maps of Ecological Risk at the sub-drainage level are also provided. Fisheries and Oceans Canada is not responsible for any omissions or errors that may be contained in this dataset and shall not be liable for any losses, financial or otherwise, due to the use of these data. Please credit Wilcox et al. 2024 as the source of the data in any maps, reports, or articles that are printed or published on paper or the Internet.

The Quartz Mining Land Use Regulations consist of a classification system based on varying levels of specific activities. These threshold levels categorize exploration activities into four classes of operation. Classes 1 through 4 represent activities with increasing potential to cause adverse environmental impacts.Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

High resolution forest change for Canada (Binary Change/No-change) 1985-2011The forest change data included in this product is national in scope (entire forested ecosystem) and represents the first wall-to-wall characterization of wildfire and harvest in Canada at a spatial resolution commensurate with human impacts. The information outcomes represent 27 years of stand replacing change in Canada’s forests, derived from a single, consistent spatially-explicit data source, derived in a fully automated manner. This demonstrated capacity to characterize forests at a resolution that captures human impacts is key to establishing a baseline for detailed monitoring of forested ecosystems from management and science perspectives. Time series of Landsat data were used to characterize national trends in stand replacing forest disturbances caused by wildfire and harvest for the period 1985–2011 for Canada's 650 million hectare forested ecosystems (https://authors.elsevier.com/sd/article/S0034425717301360 ). Landsat data has a 30m spatial resolution, so the change information is highly detailed and is commensurate with that of human impacts. These data represent annual stand replacing forest changes. The stand replacing disturbances types labeled are wildfire and harvest, with lower confidence wildfire and harvest, also shared. The distinction and sharing of lower class membership likelihoods is to indicate to users that some change events were more difficult to allocate to a change type, but are generally found to be in the correct category. For an overview on the data, image processing, and time series change detection methods applied, as well as information on independent accuracy assessment of the data, see Hermosilla et al. (2016; http://www.tandfonline.com/doi/full/10.1080/17538947.2016.1187673).The data available is, 1. a binary change/no-change; 2. Change year; and, 3. Change type. When using this data, please cite as: White, J.C., M.A. Wulder, T. Hermosilla, N.C. Coops, and G. Hobart. (2017). A nationwide annual characterization of 25 years of forest disturbance and recovery for Canada using Landsat time series. Remote Sensing of Environment. 192: 303-321. DOI: 10.1016/j.rse.2017.03.035. https://authors.elsevier.com/sd/article/S0034425717301360Geographic extent: Canada's forested ecosystems (~ 650 Mha)Time period: 1985–2011

High resolution forest change for Canada (Change Type) 1985-2011The forest change data included in this product is national in scope (entire forested ecosystem) and represents the first wall-to-wall characterization of wildfire and harvest in Canada at a spatial resolution commensurate with human impacts. The information outcomes represent 27 years of stand replacing change in Canada’s forests, derived from a single, consistent spatially-explicit data source, derived in a fully automated manner. This demonstrated capacity to characterize forests at a resolution that captures human impacts is key to establishing a baseline for detailed monitoring of forested ecosystems from management and science perspectives. Time series of Landsat data were used to characterize national trends in stand replacing forest disturbances caused by wildfire and harvest for the period 1985–2011 for Canada's 650 million hectare forested ecosystems (https://authors.elsevier.com/sd/article/S0034425717301360 ). Landsat data has a 30m spatial resolution, so the change information is highly detailed and is commensurate with that of human impacts. These data represent annual stand replacing forest changes. The stand replacing disturbances types labeled are wildfire and harvest, with lower confidence wildfire and harvest, also shared. The distinction and sharing of lower class membership likelihoods is to indicate to users that some change events were more difficult to allocate to a change type, but are generally found to be in the correct category. For an overview on the data, image processing, and time series change detection methods applied, as well as information on independent accuracy assessment of the data, see Hermosilla et al. (2016; http://www.tandfonline.com/doi/full/10.1080/17538947.2016.1187673).The data available is, 1. a binary change/no-change; 2. Change year; and, 3. Change type. When using this data, please cite as: White, J.C., M.A. Wulder, T. Hermosilla, N.C. Coops, and G. Hobart. (2017). A nationwide annual characterization of 25 years of forest disturbance and recovery for Canada using Landsat time series. Remote Sensing of Environment. 192: 303-321. DOI: 10.1016/j.rse.2017.03.035. https://authors.elsevier.com/sd/article/S0034425717301360Geographic extent: Canada's forested ecosystems (~ 650 Mha)Time period: 1985–2011