A federal electoral district is an area represented by a member of the House of Commons. The Federal Electoral Districts (FED) dataset is a digital representation of the 338 electoral districts proclaimed by the Representation Order of 2013. This dataset is an update of the 2013 Federal Electoral Districts (FED) 2013.

A systematic oceanographic monitoring program was initiated in September 1989 at twenty-five monitoring stations in the Passamaquoddy Bay area and approaches by Dr. Shawn Robinson based out of the St. Andrews Biological Station (SABS). Stations were established in a uniform grid pattern of two arcminutes latitude and longitude over the study area in order to develop a database on the spatial patterns of water properties. Monthly measurements of the water column for the temperatures and salinity at all stations was completed using a Seacat SBE 19 internally recording CTD from Sea-bird Electronics Inc. The CTD was programmed to record conductivity, temperature, and depth at a frequency of 2 hz, corresponding to 2 measurements per meter of water depth. CTD casts were recorded for each of the 25 stations in the study area monthly using the R/V Pandalus, and later the CCGS Viola M. Davidson based out of SABS. The CTD was configured such that the sensors were oriented towards the benthos and the CTD was then attached to a hydraulic winch on the deck of the ship by a stainless steel cable one meter above a weight, and lowered 1 m below the water's surface in order for the CTD to equilibrate for one minute. The CTD was then lowered at 1 m/s to the benthos using a metered block on the winch to determine when the CTD had reached the maximum depth at that station. Once the weight had touched the bottom, the CTD was retrieved from the water, turned off, and placed in a bucket of fresh seawater in order to minimize equilibration time at the next station. Initially, the CTD measured salinity via water forced through the salinity cell with the drop rate of 1 m/s, but in August 1992, a pump was mounted on the CTD in order to provide a more consistent flow of water across the salinity cell. Surface temperatures were measured from bucket samples collected upon arriving at each station using a hand-held mercury thermometer at each station, and Secchi disk measurements were recorded. All data were downloaded from the CTD upon return to SABS using a DFO computer and the proprietary Sea-Soft software. Downcast data from each profile was retained, binned into 1 m intervals, and processed to remove data spikes, density inversions, and anomalies due to inadequate instrument equilibration. Processed data was then stored in the DFO's Oracle database (PTRAN) under the IMTA_SABS schema in the INVHYD and INVINF tables. Station numbers and locations are recorded in the CTD_STATIONS table in the IMTA_SABS schema.Cite this data: Robinson, S. Data of: Passamaquoddy Bay monthly Conductivity Temperature and Depth (CTD) sampling (1989 - 2018). Published: October 2019. Coastal Ecosystems Science Division, Fisheries and Oceans Canada, St. Andrews, NB. https://open.canada.ca/data/en/dataset/12184962-7879-4214-aef0-b31162f04a27

The purpose is to provide end users with a digital data representing the boundaries of incorporated municipalities in Manitoba. It also enables users of Manitoba spatial data to identify which municipality selected features fall within.This dataset is comprised of boundary geometry for all of the incorporated municipalities and Northern Affairs Communities within the Province of Manitoba.  The boundaries in this dataset represent the descriptions set forth in the Municipal Status and Boundaries Regulation (567/88R) and subsequent amendments, and regulations under The Northern Affairs Act.  The geospatial referencing of the Municipal Boundaries is based on the best available land parcel data for each municipality and Northern Affairs Community.  Where available, cadastral data based on registered survey plans was used.  Otherwise, the Manitoba Property Assessment Information dataset produced by Manitoba Municipal Relations was used.  The delineation of the boundaries was established according to the regulation establishing or amending the boundary of a municipality or Northern Affairs Community.  Dataset content is subject to:  Ongoing changes in municipal status and boundary and Northern Affairs Community boundary alterations that are generated through annexations, amalgamations, dissolutions or formations, all of which are approved by regulations made under The Municipal Act (for incorporated municipalities) and The Northern Affairs Act (for Northern Affairs Communities).  This dataset content is current to the most recent effective date of any such regulation amendment.   Ongoing development and maintenance of the land parcel datasets.  Improvements to the cadastral data are used to improve the positional accuracy of the municipal boundary polygons.   As of the publication date of this dataset the following known issues remain:  For municipal boundaries and Northern Affairs Communities that include water boundaries, such as in the Lake Winnipeg and Lake Manitoba areas the water boundary portion that best reflects the municipal boundary was used.     In some instances, road allowances on a municipal boundary are included in both of the adjoining municipalities.   Please visit the Manitoba Municipal Relations website for more information www.gov.mb.ca/mr/land_use_dev/index.html.   The Manitoba Municipal Boundaries data reflects the status of municipal boundaries and Northern Affairs Communities at the time of export and was uploaded to Manitoba Maps as a feature layer. Fields Included: OBJECTID: Sequential unique whole numbers that are automatically generated MUNI_NO: Manitoba municipality identifier number MUNI_NAME: Legal name of municipality MUNI_TYPE: Type of municipality MUNI_LIST_NAME: Name of municipality suitable for alphabetical list MUNI_LIST_NAME_WITH_TYPE: Name of municipality suitable for alphabetical list including type

CMIST is a peer-reviewed screening-level risk assessment tool for marine invasive species (Drolet et al. 2016). It is a short questionnaire that follows the invasion process from arrival to impact and is designed so an informed assessor can evaluate one species in an assessment area in approximately one day using easily accessible information from internet databases, primary literature, and grey literature. Species can be those with an invasion history in an area or those that are candidates for future invasions.CMIST is score-based and incorporates both likelihood and impact of invasion as well as uncertainty. Questions are general to make CMIST broadly applicable to different taxa, different assessment areas, and different project goals. To date, CMIST has been tested with molluscs, tunicates, crustaceans, and polychaetes introduced or at risk of introduction to three Canadian marine ecoregions (DFO 2009). CMIST has also been successfully applied to non-indigenous freshwater fish in British Columbia with adapted guidelines (T. Therriault, pers. comm.). Upon completion, CMIST produces a risk score adjusted for the assessor’s uncertainty which, combined with information collected during the assessment, can be used to assist in management decisions. For example, in 2015, CMIST assessments were used to identify high risk invaders in three Canadian marine ecoregions (DFO 2016).

The Regional Deterministic Prediction System (RDPS) carries out physics calculations to arrive at deterministic predictions of atmospheric elements from the current day out to 84 hours into the future. Atmospheric elements include temperature, precipitation, cloud cover, wind speed and direction, humidity and others. This product contains raw numerical results of these calculations. Geographical coverage includes Canada and the United States. Data is available at horizontal resolution of about 10 km up to 33 vertical levels. Predictions are performed four times a day.Note: The Regional Deterministic Prediction System is now a component of the Global Deterministic Prediction System (GDPS) at 10 km resolution, over a North American domain.

Each pixel value corresponds to the difference (anomaly) between the mean “Best-Quality” Max-NDVI of the week specified (e.g. Week 18, 2000-2014) and the “Best-Quality” Max-NDVI of the same week in a specific year (e.g. Week 18, 2015). Max-NDVI anomalies < 0 indicate where weekly Max-NDVI is lower than normal. Anomalies > 0 indicate where weekly Max-NDVI is higher than normal. Anomalies close to 0 indicate where weekly Max-NDVI is similar to normal.

Hospitals and other health care facilities in BC that provide 24-hour diagnostic and treatment services for people who have acute, life-threatening injuries or severe illnesses. Definition is protected by Copyright by Information and Referral Federal of Los Angeles County, Inc (https://211taxonomy.org/subscriptions/#agreement)

The Canada Nature Fund for Aquatic Species at Risk (CNFASAR) is a contribution program that focuses on providing funding for recovery and threat mitigation activities in nine priority places and to address two marine threats to aquatic species at risk. The Priority Places and Marine Threats layer supports CNFASAR by delineating the location of the places and threats.The Canada Nature Fund for Aquatic Species at Risk (CNFASAR) supports applicants in the design and delivery of stewardship projects. These projects support the recovery and protection of aquatic species at risk. DFO has identified 2 priority marine threats and 9 priority places as the focus for projects funded by CNFASAR, these areas are included in this dataset.

644 datasets of Typical Meteorological Years (TMY) created by joining twelve Typical Meteorological Months selected from a database of up to 20 years of CWEEDS hourly data. The months are chosen by statistically comparing individual monthly means with long-term monthly means for daily total global solar irradiance, mean, minimum and maximum dry bulb temperature, mean, minimum and maximum dew point temperature, and mean and maximum wind speed. These hourly datasets are used by the engineering and scientific community mainly as inputs for solar system design and analysis and building energy systems analysis tools. This dataset has been updated with the most recent changes made in March 2023. The solar values in these files are based on 0.1° x 0.1° (11 km x 11 km grid) for all of Canada. Refer to Data Resources below for additional information on the TMY file format.

Statistics Canada, in collaboration with the Public Health Agency of Canada and Natural Resources Canada, is presenting selected Census data to help inform Canadians on the public health risk of the COVID-19 pandemic and to be used for modelling analysis. The data provided here show the counts of the population in nursing homes and/or residences for senior citizens by broad age groups (0 to 79 years and 80 years and over) and sex, from the 2016 Census.Nursing homes and/or residences for senior citizens are facilities for elderly residents that provide accommodations with health care services or personal support or assisted living care.Health care services include professional health monitoring and skilled nursing care and supervision 24 hours a day, 7 days a week, for people who are not independent in most activities of daily living.Support or assisted living care services include meals, housekeeping, laundry, medication supervision, assistance in bathing or dressing, etc., for people who are independent in most activities of daily living.Included are nursing homes, residences for senior citizens, and facilities that are a mix of both a nursing home and a residence for senior citizens.Excluded are facilities licensed as hospitals, and facilities that do not provide any services (which are considered private dwellings).