## Get data on areas where outdoor fires are not permitted. This dataset shows areas where outdoor fires are restricted in accordance with the [Forest Fires Prevention Act](https://www.ontario.ca/laws/statute/90f24). There are two reasons why a restricted fire zone is in effect: * outdoor conditions are extremely dry * the number of fires occurring has stretched firefighting resources to capacity A restricted fire zone is a temporary measure for extreme situations and is lifted as soon as conditions permit. The [Forest Fire Info Map](https://www.lioapplications.lrc.gov.on.ca/ForestFireInformationMap/index.html?viewer=FFIM.FFIM) shows active fires, current fire danger and restricted fire zones in place due to high fire danger.

Wildfire historic incident point locations for all fire seasons before the current season. Supplied through various sources. Not to be used for legal purposes. This data includes all incidents tracked by BC Wildfire Service, ie. actual fires, suspected fires, nusiance fires, smoke chases, etc. On April 1 of each year this layer is updated with the previous fire season's data

This dataset shows the locations of ignition points for forest fires less than 40 hectares in size. Fires that grow larger than 40 hectares are mapped in the [Fire Disturbance Area](https://data.ontario.ca/dataset/fire-disturbance-area-firedstb) dataset. The [Forest Fire Info Map](https://www.gisapplication.lrc.gov.on.ca/ForestFireInformationMap/index.html?viewer=FFIM.FFIM&locale=en-US) shows active fires, current fire danger and restricted fire zones in place due to high fire danger.

A Fire Disturbance Area represents the mapped exterior perimeter of a forest fire. Mapping is derived from a variety of sources, such as GPS points and digitized paper maps. Prior to 1998, only fires greater than 200 hectares were mapped. Since 1998, fires greater than 40 hectares have been mapped. If adequate mapping exists for fires less than 40 hectares in size, they will be included in this data class. The [Forest Fire Info Map](https://www.lioapplications.lrc.gov.on.ca/ForestFireInformationMap/index.html?viewer=FFIM.FFIM) shows active fires, current fire danger and restricted fire zones in place due to high fire danger.

Wildfire perimeters for the current fire season, including both active and inactive fires, supplied from various sources. The data is refreshed from operational systems every 15 min. These perimeters are rolled over to Historical Fire Polygons on April 1 of each year Wildfire data may not reflect the most current fire situation, and therefore should only be used for reference purposes. Wildfire data is refreshed when practicable and individual fire update frequency will vary. The information is intended for general purposes only and should not be relied on as accurate because fires are dynamic and circumstances may change quickly.

This is a landscape level GIS coverage of large fires within the Yukon, spanning a period from 1946 to present. Original polygon size was limited to 200 hectares, when the first edition of this dataset was completed in 1997. Smaller fires are now being included, especially near communities. It is important to note that in most instances, fire perimeters only were mapped. This means that unburned areas within the perimeter are not accounted for, either in an ecological context or in annual area burned summaries. More recent fires mapped, with the aid of satellite technology may include large unburned patches.Although the temporal scale of the coverage goes back to late 1940's, Yukon-wide fire detection capability was not fully developed until the 1960's. In addition to this, access to regular aerial mapping was not readily available until that same time period. As a result many fires in the 40's and 50's were simply not recorded or poorly mapped, particularly in the north. For that reason, care must be taken when drawing conclusions from these data as it relates to the early years.Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Wildfire location points for the current fire season. This includes both active and inactive fires. Data is supplied through various sources and is updated from the operational systems every 15 minutes. These points are rolled over to Historical Fire Points on April 1 of each year. Wildfire data may not reflect the most current fire situation, and therefore should only be used for reference purposes. Wildfire data is refreshed when practicable and individual fire update frequency will vary. The information is intended for general purposes only and should not be relied on as accurate because fires are dynamic and circumstances may change quickly.

The fire regime describes the patterns of fire seasonality, frequency, size, spatial continuity, intensity, type (e.g., crown or surface fire) and severity in a particular area or ecosystem.The number of large fires refers to the annual number of fires greater than 200 hectares (ha) that occur per units of 100,000 ha. It was calculated per Homogeneous Fire Regime (HFR) zones. These HFR zones represent areas where the fire regime is similar over a broad spatial scale (Boulanger et al. 2014). Such zonation is useful in identifying areas with unusual fire regimes that would have been overlooked if fires had been aggregated according to administrative and/or ecological classifications.Fire data comes from the Canadian National Fire Database covering 1959–1999 (for HFR zones building) and 1959-1995 (for model building). Multivariate Adaptive Regression Splines (MARS) modeling was used to relate monthly fire regime attributes with monthly climatic/fire-weather in each HFR zone. Future climatic data were simulated using the Canadian Earth System Model version 2 (CanESM2) and downscaled at a 10 Km resolution using ANUSPLIN for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: the number of large fires (>200 ha) across Canada for a reference period (1981-2010).Reference: Boulanger, Y., Gauthier, S., et al. 2014. A refinement of models projecting future Canadian fire regimes using homogeneous fire regime zones. Canadian Journal of Forest Research 44, 365–376.

The fire regime describes the patterns of fire seasonality, frequency, size, spatial continuity, intensity, type (e.g., crown or surface fire) and severity in a particular area or ecosystem.The number of large fires refers to the annual number of fires greater than 200 hectares (ha) that occur per units of 100,000 ha. It was calculated per Homogeneous Fire Regime (HFR) zones. These HFR zones represent areas where the fire regime is similar over a broad spatial scale (Boulanger et al. 2014). Such zonation is useful in identifying areas with unusual fire regimes that would have been overlooked if fires had been aggregated according to administrative and/or ecological classifications.Fire data comes from the Canadian National Fire Database covering 1959–1999 (for HFR zones building) and 1959-1995 (for model building). Multivariate Adaptive Regression Splines (MARS) modeling was used to relate monthly fire regime attributes with monthly climatic/fire-weather in each HFR zone. Future climatic data were simulated using the Canadian Earth System Model version 2 (CanESM2) and downscaled at a 10 Km resolution using ANUSPLIN for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: projected number of large fires (>200 ha) across Canada for the medium-term (2041-2070) under the RCP 8.5 (continued emissions increases).Reference: Boulanger, Y., Gauthier, S., et al. 2014. A refinement of models projecting future Canadian fire regimes using homogeneous fire regime zones. Canadian Journal of Forest Research 44, 365–376.

The fire regime describes the patterns of fire seasonality, frequency, size, spatial continuity, intensity, type (e.g., crown or surface fire) and severity in a particular area or ecosystem.The number of large fires refers to the annual number of fires greater than 200 hectares (ha) that occur per units of 100,000 ha. It was calculated per Homogeneous Fire Regime (HFR) zones. These HFR zones represent areas where the fire regime is similar over a broad spatial scale (Boulanger et al. 2014). Such zonation is useful in identifying areas with unusual fire regimes that would have been overlooked if fires had been aggregated according to administrative and/or ecological classifications.Fire data comes from the Canadian National Fire Database covering 1959–1999 (for HFR zones building) and 1959-1995 (for model building). Multivariate Adaptive Regression Splines (MARS) modeling was used to relate monthly fire regime attributes with monthly climatic/fire-weather in each HFR zone. Future climatic data were simulated using the Canadian Earth System Model version 2 (CanESM2) and downscaled at a 10 Km resolution using ANUSPLIN for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: projected number of large fires (>200 ha) across Canada for the short-term (2011-2040) under the RCP 8.5 (continued emissions increases).Reference: Boulanger, Y., Gauthier, S., et al. 2014. A refinement of models projecting future Canadian fire regimes using homogeneous fire regime zones. Canadian Journal of Forest Research 44, 365–376.