Regional Deterministic Air Quality Analysis (RDAQA) is an objective analysis of surface pollutants that combines numerical forecasts from the Regional Air Quality Deterministic Prediction System (RAQDPS) with hourly observations from various monitoring networks in North America, including the Canadian measurement networks operated by the provinces, territories and certain cities, as well as the various American networks in the context of the AIRNow program administered by US/EPA (US Environmental Protection Agency). RDAQA analysis provides the best description of current air quality conditions, and is used to inform the public, meteorologists in the various Environment and Climate Change Canada forecasting offices, Health Canada and other users about the distribution of air pollutants near the ground, and the performance of forecasting models. Each hour, a preliminary product is available approximately one hour after the observation measurement time, while final and Firework products are available approximately two hours after the measurement time. The preliminary and final products contain analysis of the chemical constituents O3, SO2, NO, NO2, PM2.5 (fine particles with diameters of 2.5 micrometers or less) and PM10 (coarse particles with diameters of 10 micrometers or less), while the Firework product contains analysis of PM2.5 and PM10.

The Regional Deterministic Air Quality Analysis (RDAQA) is an objective analysis of surface pollutants which combines numerical forecasts from the Regional Air Quality Deterministic Prediction System (RAQDPS) and hourly observational data from monitoring surface networks over North America in order to produce a better description of the air quality at every hour. Chemical constituents include 03, SO2, and NO2 gases, as well as fine particulate matter PM2.5 (2.5 micrometers in diameter or less) and coarse particulate matter PM10 (10 micrometers in diameter or less). Geographical coverage is Canada and the United States. Data is available only for the surface level, at a horizontal resolution of 10 km. The products are presented as historical, annual or monthly, averages which highlight long-term trends in cumulative effects on the environment.

The Regional Air Quality Deterministic Prediction System (RAQDPS) takes into account physical and chemical processes to produce deterministic forecasts of the concentration of chemical species of interest to air quality. These chemical constituents include gases such as O3, SO2, NO, and NO2, in addition to fine particles PM2.5 (diameter of 2.5 micrometers or less) and coarse particles PM10 (diameter of 10 micrometers or less). The PM2.5 and PM10 now include the contribution of wildfire emissions as well as anthropogenic and biogenic emission sources. The forecasts are available for the present up to 72 hours in the future twice a day (run 00 UTC and 12 UTC). The geographic domain of the RAQDPS covers most of North America with a horizontal resolution of 10km.

This dataset includes all MPMO projects at various stages in the review process, including those that are currently undergoing review and those that have completed a review.

Multi-model ensembles of mean temperature based on projections from twenty-nine Coupled Model Intercomparison Project Phase 5 (CMIP5) global climate models are available for 1901-2100. Specifically, the 5th, 25th, 50th, 75th and 95th percentiles of the monthly, seasonal and annual ensembles of mean temperature (°C) are available for the historical time period, 1901-2005, and for emission scenarios, RCP2.6, RCP4.5 and RCP8.5, for 2006-2100. Note: Projections among climate models can vary because of differences in their underlying representation of earth system processes. Thus, the use of a multi-model ensemble approach has been demonstrated in recent scientific literature to likely provide better projected climate change information.

Updated 2025-02-21. Feature layer of current Boil Water Advisories issued for Public Water Systems (PWS) in Manitoba.Feature layer of current Boil Water Advisories issued for Public Water Systems (PWS) in Manitoba.

Wildfire Year/dNBR/Mask 1985-2015Wildfire change magnitude 85-15. Spectral change magnitude for wildfires that occurred from 1985 and 2015. The wildfire change magnitude included in this product is expressed via differenced Normalized Burn Ratio (dNBR), computed as the variation between the spectral values before and after the change event. This dataset is composed of three layers: (1) binary wildfire mask, (2) year of greatest wildfire disturbance, and (3) differenced Normalized Burn Ratio (dNBR) transformed for data storage efficiency to the range 0-200. The actual dNBR value is derived as follows: dNBR = value / 100. Higher dNBR values are related to higher burn severity. The information outcomes represent 30 years of wildfires in Canada's forests, derived from a single, consistent spatially-explicit data source in a fully automated manner. Time series of Landsat data with 30-m spatial resolution were used to characterize national trends in stand replacing forest disturbances caused by wildfire for the period 1985-2015 for Canada's 650 million hectare forested ecosystems.When using this data, please cite as: Hermosilla, T., M.A. Wulder, J.C. White, N.C. Coops, G.W. Hobart, L.B. Campbell, 2016. Mass data processing of time series Landsat imagery: pixels to data products for forest monitoring. International Journal of Digital Earth 9(11), 1035-1054. (Hermosilla et al. 2016).See references below for an overview on the data processing, metric calculation, change attribution and time series change detection methods applied, as well as information on independent accuracy assessment of the data.Hermosilla, T., Wulder, M. A., White, J. C., Coops, N.C., Hobart, G.W., 2015. An integrated Landsat time series protocol for change detection and generation of annual gap-free surface reflectance composites. Remote Sensing of Environment 158, 220-234. (Hermosilla et al. 2015a).Hermosilla, T., Wulder, M.A., White, J.C., Coops, N.C., Hobart, G.W., 2015. Regional detection, characterization, and attribution of annual forest change from 1984 to 2012 using Landsat-derived time-series metrics. Remote Sensing of Environment 170, 121-132. (Hermosilla et al. 2015b).Geographic extent: Canada's forested ecosystems (~ 650 Mha)Time period: 1985–2011

The HealthLink BC Mental Health and Substance Use (MHSU) data set includes the following: Programs that offer early intervention, transitional care or other services that supplement and facilitate primary and adjunctive therapies; which offer community mental health education programs; or which link people who are in need of treatment with appropriate providers. Programs that provide preventive, diagnostic and treatment services in a variety of community and hospital-based settings to help people achieve, maintain and enhance a state of emotional well-being, personal empowerment and the skills to cope with everyday demands without excessive stress or reliance on alcohol or other drugs. Treatment may include emotional support, introspection and problem-solving assistance using a variety of modalities and approaches, and medication, as needed, for individuals who have a substance use disorder involving alcohol and/or other drugs or for people who range from experiencing difficult life transitions or problems in coping with daily living to those with severe, chronic mental illnesses that seriously impact their lives. Multidisciplinary programs, often offered on an inpatient basis with post-discharge outpatient therapy, that provide comprehensive diagnostic and treatment services for individuals who have anorexia nervosa, binge-eating disorder, bulimia or a related eating disorder. Treatment depends on the specific type of eating disorder involved but typically involves psychotherapy, nutrition education, family counseling, medication and hospitalization, if required, to stabilize the patient's health. Alliance of Information & Referral Systems (AIRS) / 211 LA County taxonomy is the data classification used for all HealthLink BC directory data, including this MHSU data set (https://www.airs.org/i4a/pages/index.cfm?pageid=1). AIRS taxonomy and data definitions are protected by Copyright by Information and Referral Federal of Los Angeles County, Inc (https://211taxonomy.org/subscriptions/#agreement)

Heat Wave represents the consecutive number of days (April 1 – October 31) where the maximum daily temperature is greater than 25 or 30 degrees respectively. Heat wave products are only generated during the Growing Season, April 1 through October 31.

As part of special projects, the Air Quality Monitoring Network (RSQA) measures the concentrations of pollutants at the nomadic station. Its objective is to deepen our knowledge of ambient air quality. As its name indicates, this station will change location at the end of each measurement campaign, which may last from 12 to 24 months.The Nomad station continuously measures: ozone (O3), fine particles (PM2.5), carbon monoxide (CO), sulfur dioxide (SO2), nitrogen oxides (NOx), elemental carbon (CE) and ultrafine particles (PUF); as well as spot measurements of breathable particles (PM10) and total suspended particles (PST) with metal analysis on the latter.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**