Results of the last hour available, in real time, of the [Air Quality Index (AQI)] (https://www.iqa.environnement.gouv.qc.ca/contenu/index.asp) for the stations of the [Quebec Air Quality Monitoring Network] (https://www.environnement.gouv.qc.ca/air/reseau-surveillance/Carte.asp). These results exclude those from stations located on [Montreal Island] (https://www.donneesquebec.ca/recherche/dataset/vmtl-rsqa-indice-qualite-air).The IQA is an information and awareness tool designed to inform the population about the quality of ambient air in Quebec.If you have any questions about this data, contact the Info-Air department:.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

Each pixel value corresponds to the difference (anomaly) between the mean “Best-Quality” Max-NDVI of the week specified (e.g. Week 18, 2000-2014) and the “Best-Quality” Max-NDVI of the same week in a specific year (e.g. Week 18, 2015). Max-NDVI anomalies < 0 indicate where weekly Max-NDVI is lower than normal. Anomalies > 0 indicate where weekly Max-NDVI is higher than normal. Anomalies close to 0 indicate where weekly Max-NDVI is similar to normal.

The Air Quality Health Index (AQHI) is a scale designed to help quantify the quality of the air in a certain region on a scale from 1 to 10. When the amount of air pollution is very high, the number is reported as 10+. It also includes a category that describes the health risk associated with the index reading (e.g. Low, Moderate, High, or Very High Health Risk). The AQHI is calculated based on the relative risks of a combination of common air pollutants that are known to harm human health, including ground-level ozone, particulate matter, and nitrogen dioxide. The AQHI formulation captures only the short term or acute health risk (exposure of hour or days at a maximum). The formulation of the AQHI may change over time to reflect new understanding associated with air pollution health effects. The AQHI is calculated from data observed in real time, without being verified (quality control).

The theme on physicochemical monitoring of rivers and rivers presents data from all stations in networks monitoring water quality in rivers in Quebec and the St. Lawrence River.The purpose of networks for monitoring general water quality is to characterize, using current physicochemical and bacteriological parameters, the quality of water in spatial terms and to monitor the evolution of this quality over time. For the regular monitoring of the general quality of river and river water, the parameters measured are: total phosphorus, total nitrogen, nitrites and nitrates, ammonia nitrogen, chlorophyll a, pheopigments, faecal coliforms, faecal coliforms, turbidity, suspended matter, pH, conductivity, dissolved organic carbon and temperature. This data is used to calculate the Bacteriological and Physicochemical Water Quality Index (IQBP), a water quality classification index.The data set on physicochemical monitoring of rivers and rivers also includes the drainage areas of some of the stations. The attribute table provides a compilation of land use by category for the last year available at the time the data was generated. Follow-up is carried out annually.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

This dataset contains the validated hourly results of the [Air Quality Index (AQI)] (https://www.iqa.environnement.gouv.qc.ca/contenu/index.asp) and its sub-indices for each station in the [Quebec Air Quality Monitoring Network (RSQAQ)] (https://www.environnement.gouv.qc.ca/air/reseau-surveillance/Carte.asp).The results of the stations in the city of Montreal are not included. To obtain them, consult the dataset [RSQA - air quality index (historical)] ([measured on the island of Montreal] (https://www.donneesquebec.ca/recherche/dataset/vmtl-rsqa-polluants-gazeux)).The IQA is an information and awareness tool designed to inform the population about the quality of ambient air in Quebec.If you have any questions about this data, contact the Info-Air department:.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

Each pixel value corresponds to the best quality maximum NDVI recorded within that pixel over the week specified. Poor quality pixel observations are removed from this product. Observations whose quality is degraded by snow cover, shadow, cloud, aerosols, and/or low sensor zenith angles are removed (and are assigned a value of “missing data”). In addition, negative Max-NDVI values, occurring where R reflectance > NIR reflectance, are considered non-vegetated and assigned a value of 0. This results in a Max-NDVI product that should (mostly) contain vegetation-covered pixels. Max-NDVI values are considered high quality and span a biomass gradient ranging from 0 (no/low biomass) to 1 (high biomass).

Each pixel value corresponds to the actual number (count) of valid Best-quality Max-NDVI values used to calculate the mean weekly values for that pixel. Since 2020, the maximum number of possible observations used to create the Mean Best-Quality Max-NDVI for the 2000-2014 period is n=20. However, because data quality varies both temporally and geographically (e.g. cloud cover and snow cover in spring; cloud near large water bodies all year), the actual number (count) of observations used to create baselines can vary significantly for any given week and year.

The Canadian Environmental Sustainability Indicators (CESI) program provides data and information to track Canada's performance on key environmental sustainability issues. The Water quality in Canadian rivers indicators provide a measure of the ability of river water across Canada to support plants and animals. At each monitoring site, water quality data are compared to water quality guidelines to create a rating for the site. If measured water quality is below the guidelines, it can maintain a healthy ecosystem. Water quality at a monitoring site is considered excellent when substances in a river are very rarely measured above their guidelines. Conversely, water quality is rated poor when measurements are usually above their guidelines, sometimes by a wide margin. These indicators provide information about the state of surface water quality and its change through time, to support water resource management. Information is provided to Canadians in a number of formats including: static and interactive maps, charts and graphs, HTML and CSV data tables and downloadable reports. See the supplementary documentation for the data sources and details on how the data were collected and how the indicator was calculated.Canadian Environmental Sustainability Indicators - Home page:https://www.canada.ca/environmental-indicators

The Riparian Quality Index (IQBR) is used to assess the ecological condition of the shoreline environment. It is built from nine components that have been weighted according to their potential to perform ecological functions in terms of the protection of aquatic ecosystems.Data on shoreline quality come from benthos monitoring stations sampled between 2003 and 2023.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

Each pixel value corresponds to the day-of-week (1-7) from which the Weekly Best-Quality NDVI retrieval is obtained (1 = Monday, 7 = Sunday).