A predictive model for Canadian carbonatite-hosted REE ± Nb deposits is presented herein. This model was developed by integrating diverse data layers derived from geophysical, geochronological, and geological sources. These layers represent the key components of carbonatite-hosted REE ± Nb mineral systems, including the source, transport mechanisms, geological traps, and preservation processes. Deep learning algorithms were employed to integrate these layers into a comprehensive predictive framework. Here is a link to the publication that describes this product: https://link.springer.com/article/10.1007/s11053-024-10369-7

Facilities that separate and convert crude oil or other feedstock into liquid petroleum products, including upgraders and asphalt refineries.Mapping Resources implemented as part of the North American Cooperation on Energy Information (NACEI) between the Department of Energy of the United States of America, the Department of Natural Resources of Canada, and the Ministry of Energy of the United Mexican States.The participating Agencies and Institutions shall not be held liable for improper or incorrect use of the data described and/or contained herein. These data and related graphics, if available, are not legal documents and are not intended to be used as such. The information contained in these data is dynamic and may change over time and may differ from other official information. The Agencies and Institutions participants give no warranty, expressed or implied, as to the accuracy, reliability, or completeness of these data.

Trails designed for hiking.attribut:ID - Unique identifier**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

Rouyn-Noranda cycling network**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

The entire road network of the City of Rouyn-Noranda. Only the lanesPublics with an odonym are included.**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

Location of timestampers.attributs:ID - Unique IdentifierNo - Number**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

The spatial representation for a Forest Addition, which is any Forest land that is to be designated by the Lieutenant Governor, into an established forest, to be managed and used for the social and economic benefit of the Province

Regional stream sediment geochemical data compilationNovember 2020Release notesThe regional stream sediment geochemical data compilation comprises data for more than 30 000 samples across Yukon. This compilation updates the work of Héon (2003). This new compilation includes results from the reanalysis of more than 24 000 samples; inductively coupled plasma mass spectrometry (ICPMS) analysis provides upgraded detection limits and a broader range of elements relative to previous analytical data. In addition to analytical data, efforts have been made to improve sample location accuracy. The data in this release are organized by analytical method with the geodatabase having six feature classes:1. RGS_SITE_WATER - site specific physiography and water quality data. These data are unchanged from the original releases. 2. RGS_HEON - the same data as released in Héon (2003) with minor updates to sample location. 3. RGS_AAS - all samples analyzed by atomic absorption spectrometry. Most of these data are superseded by INAA and ICPMS data. 4. RGS_INAA - all samples analyzed by instrumental neutron activation analysis (INAA) and fire assay-neutron activation (FA-NA) analysis. 5. RGS_ICPMS - all samples analyzed by inductively coupled plasma mass spectrometry (ICPMS). 6. RGS_All - includes all AAS, INAA and ICPMS data. Collection of stream sediment samples in Yukon began in 1976 and ended in 2006. Three analytical methods have been used to analyze the minus 0.177 mm fraction (-80 mesh) of these samples: AAS, INNA (and FA-NA) and ICPMS. A simple description of each method is given below.For atomic absorption spectrometry (AAS) a 1 g aliquot is 'partially digested' using Lefort aqua regia or concentrated hot nitric acid. The digestion product is analyzed using an atomic absorption spectrometer. Oxide and silicate minerals are partially digested while some sulphide minerals are erratically volatilized. This means that AAS cannot be used to obtain accurate REE, Ta, Nb, As, Sb, Sn, Hg, Cr, or Au determinations.For instrumental neutron activation analysis ( INAA), aliquots of sieved sediment (the minus 0.177 mm fraction) or milled rock ranging from 5 to 40 g are encapsulated and irradiated in a nuclear reactor before counting the primary gamma radiation induced by the neutron irradiation with a high resolution germanium gamma ray detector. Fire assay-neutron activation (FA-NA) analysis is similar but includes a pre-concentration fire assay step prior to irradiation and analysis. Results for both INAA and FA-NA are similar to those for samples analyses by fusion or other total digestion techniques. Neutron activation detection limits are typically higher than those by acid digestion - ICPMS. Commodity and pathfinder elements such as Au, As, Sb and W have reasonable detection limits by INAA and the data generated are relatively precise.For ICPMS analysis, aliquots of sieved sediment ( the minus 0.177 mm fraction) ranging from 0.5 to 1 g are prepared using a partial digestion technique, typically aqua regia, followed by analysis of dissolution product by ICPMS. Sulphide minerals are completely oxidized and dissolved whereas most oxide and silicate minerals are only partially digested. This means that results produced by partial digestion methods are acceptable for elements such as Ag, As, Mo, Ni, Pb, Sb, Tl, and Zn but values for elements such as Al, Ba, Cr, Fe, P, Sn, Ti, Y, and Zr are likely to not reflect the actual element concentration in a sample. The sample size used for routine RGS sample analysis is too small be representative of Au in the original sample and thus Au by aqua regia digestion - ICPMS has poor precision.Further upgrades to this database are not anticipated. All samples that could be found in the GSC-Ottawa warehouse have been reanalyzed using ICPMS. Any errors or omissions in this database should be reported to the Yukon Geological Survey. Your feedback contributes to improving the accuracy of the geoscience databases for Yukon.Contact: [YGSMinerals@yukon.ca](mailto:YGSMinerals@yukon.ca) ; [geology@yukon.ca](mailto:geology@yukon.ca)Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Regional stream sediment geochemical data compilationNovember 2020Release notesThe regional stream sediment geochemical data compilation comprises data for more than 30 000 samples across Yukon. This compilation updates the work of Héon (2003). This new compilation includes results from the reanalysis of more than 24 000 samples; inductively coupled plasma mass spectrometry (ICPMS) analysis provides upgraded detection limits and a broader range of elements relative to previous analytical data. In addition to analytical data, efforts have been made to improve sample location accuracy. The data in this release are organized by analytical method with the geodatabase having six feature classes:1. RGS_SITE_WATER - site specific physiography and water quality data. These data are unchanged from the original releases. 2. RGS_HEON - the same data as released in Héon (2003) with minor updates to sample location. 3. RGS_AAS - all samples analyzed by atomic absorption spectrometry. Most of these data are superseded by INAA and ICPMS data. 4. RGS_INAA - all samples analyzed by instrumental neutron activation analysis (INAA) and fire assay-neutron activation (FA-NA) analysis. 5. RGS_ICPMS - all samples analyzed by inductively coupled plasma mass spectrometry (ICPMS). 6. RGS_All - includes all AAS, INAA and ICPMS data. Collection of stream sediment samples in Yukon began in 1976 and ended in 2006. Three analytical methods have been used to analyze the minus 0.177 mm fraction (-80 mesh) of these samples: AAS, INNA (and FA-NA) and ICPMS. A simple description of each method is given below.For atomic absorption spectrometry (AAS) a 1 g aliquot is 'partially digested' using Lefort aqua regia or concentrated hot nitric acid. The digestion product is analyzed using an atomic absorption spectrometer. Oxide and silicate minerals are partially digested while some sulphide minerals are erratically volatilized. This means that AAS cannot be used to obtain accurate REE, Ta, Nb, As, Sb, Sn, Hg, Cr, or Au determinations.For instrumental neutron activation analysis ( INAA), aliquots of sieved sediment (the minus 0.177 mm fraction) or milled rock ranging from 5 to 40 g are encapsulated and irradiated in a nuclear reactor before counting the primary gamma radiation induced by the neutron irradiation with a high resolution germanium gamma ray detector. Fire assay-neutron activation (FA-NA) analysis is similar but includes a pre-concentration fire assay step prior to irradiation and analysis. Results for both INAA and FA-NA are similar to those for samples analyses by fusion or other total digestion techniques. Neutron activation detection limits are typically higher than those by acid digestion - ICPMS. Commodity and pathfinder elements such as Au, As, Sb and W have reasonable detection limits by INAA and the data generated are relatively precise.For ICPMS analysis, aliquots of sieved sediment ( the minus 0.177 mm fraction) ranging from 0.5 to 1 g are prepared using a partial digestion technique, typically aqua regia, followed by analysis of dissolution product by ICPMS. Sulphide minerals are completely oxidized and dissolved whereas most oxide and silicate minerals are only partially digested. This means that results produced by partial digestion methods are acceptable for elements such as Ag, As, Mo, Ni, Pb, Sb, Tl, and Zn but values for elements such as Al, Ba, Cr, Fe, P, Sn, Ti, Y, and Zr are likely to not reflect the actual element concentration in a sample. The sample size used for routine RGS sample analysis is too small be representative of Au in the original sample and thus Au by aqua regia digestion - ICPMS has poor precision.Further upgrades to this database are not anticipated. All samples that could be found in the GSC-Ottawa warehouse have been reanalyzed using ICPMS. Any errors or omissions in this database should be reported to the Yukon Geological Survey. Your feedback contributes to improving the accuracy of the geoscience databases for Yukon.Contact: [YGSMinerals@yukon.ca](mailto:YGSMinerals@yukon.ca) ; [geology@yukon.ca](mailto:geology@yukon.ca)Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Regional stream sediment geochemical data compilationNovember 2020Release notesThe regional stream sediment geochemical data compilation comprises data for more than 30 000 samples across Yukon. This compilation updates the work of Héon (2003). This new compilation includes results from the reanalysis of more than 24 000 samples; inductively coupled plasma mass spectrometry (ICPMS) analysis provides upgraded detection limits and a broader range of elements relative to previous analytical data. In addition to analytical data, efforts have been made to improve sample location accuracy. The data in this release are organized by analytical method with the geodatabase having six feature classes:1. RGS_SITE_WATER - site specific physiography and water quality data. These data are unchanged from the original releases. 2. RGS_HEON - the same data as released in Héon (2003) with minor updates to sample location. 3. RGS_AAS - all samples analyzed by atomic absorption spectrometry. Most of these data are superseded by INAA and ICPMS data. 4. RGS_INAA - all samples analyzed by instrumental neutron activation analysis (INAA) and fire assay-neutron activation (FA-NA) analysis. 5. RGS_ICPMS - all samples analyzed by inductively coupled plasma mass spectrometry (ICPMS). 6. RGS_All - includes all AAS, INAA and ICPMS data. Collection of stream sediment samples in Yukon began in 1976 and ended in 2006. Three analytical methods have been used to analyze the minus 0.177 mm fraction (-80 mesh) of these samples: AAS, INNA (and FA-NA) and ICPMS. A simple description of each method is given below.For atomic absorption spectrometry (AAS) a 1 g aliquot is 'partially digested' using Lefort aqua regia or concentrated hot nitric acid. The digestion product is analyzed using an atomic absorption spectrometer. Oxide and silicate minerals are partially digested while some sulphide minerals are erratically volatilized. This means that AAS cannot be used to obtain accurate REE, Ta, Nb, As, Sb, Sn, Hg, Cr, or Au determinations.For instrumental neutron activation analysis ( INAA), aliquots of sieved sediment (the minus 0.177 mm fraction) or milled rock ranging from 5 to 40 g are encapsulated and irradiated in a nuclear reactor before counting the primary gamma radiation induced by the neutron irradiation with a high resolution germanium gamma ray detector. Fire assay-neutron activation (FA-NA) analysis is similar but includes a pre-concentration fire assay step prior to irradiation and analysis. Results for both INAA and FA-NA are similar to those for samples analyses by fusion or other total digestion techniques. Neutron activation detection limits are typically higher than those by acid digestion - ICPMS. Commodity and pathfinder elements such as Au, As, Sb and W have reasonable detection limits by INAA and the data generated are relatively precise.For ICPMS analysis, aliquots of sieved sediment ( the minus 0.177 mm fraction) ranging from 0.5 to 1 g are prepared using a partial digestion technique, typically aqua regia, followed by analysis of dissolution product by ICPMS. Sulphide minerals are completely oxidized and dissolved whereas most oxide and silicate minerals are only partially digested. This means that results produced by partial digestion methods are acceptable for elements such as Ag, As, Mo, Ni, Pb, Sb, Tl, and Zn but values for elements such as Al, Ba, Cr, Fe, P, Sn, Ti, Y, and Zr are likely to not reflect the actual element concentration in a sample. The sample size used for routine RGS sample analysis is too small be representative of Au in the original sample and thus Au by aqua regia digestion - ICPMS has poor precision.Further upgrades to this database are not anticipated. All samples that could be found in the GSC-Ottawa warehouse have been reanalyzed using ICPMS. Any errors or omissions in this database should be reported to the Yukon Geological Survey. Your feedback contributes to improving the accuracy of the geoscience databases for Yukon.Contact: [YGSMinerals@yukon.ca](mailto:YGSMinerals@yukon.ca) ; [geology@yukon.ca](mailto:geology@yukon.ca)Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)