The Regional Deterministic Air Quality Analysis (RDAQA) is an objective analysis of surface pollutants which combines numerical forecasts from the Regional Air Quality Deterministic Prediction System (RAQDPS) and hourly observational data from monitoring surface networks over North America in order to produce a better description of the air quality at every hour. Chemical constituents include 03, SO2, and NO2 gases, as well as fine particulate matter PM2.5 (2.5 micrometers in diameter or less) and coarse particulate matter PM10 (10 micrometers in diameter or less). Geographical coverage is Canada and the United States. Data is available only for the surface level, at a horizontal resolution of 10 km. The products are presented as historical, annual or monthly, averages which highlight long-term trends in cumulative effects on the environment.

Regional Deterministic Air Quality Analysis (RDAQA) is an objective analysis of surface pollutants that combines numerical forecasts from the Regional Air Quality Deterministic Prediction System (RAQDPS) with hourly observations from various monitoring networks in North America, including the Canadian measurement networks operated by the provinces, territories and certain cities, as well as the various American networks in the context of the AIRNow program administered by US/EPA (US Environmental Protection Agency). RDAQA analysis provides the best description of current air quality conditions, and is used to inform the public, meteorologists in the various Environment and Climate Change Canada forecasting offices, Health Canada and other users about the distribution of air pollutants near the ground, and the performance of forecasting models. Each hour, a preliminary product is available approximately one hour after the observation measurement time, while final and Firework products are available approximately two hours after the measurement time. The preliminary and final products contain analysis of the chemical constituents O3, SO2, NO, NO2, PM2.5 (fine particles with diameters of 2.5 micrometers or less) and PM10 (coarse particles with diameters of 10 micrometers or less), while the Firework product contains analysis of PM2.5 and PM10.

Caribou habitat management areas identify zones ("tiers") with similar importance to caribou, potential risks and primary strategies for caribou conservation.These Final Caribou Habitat Management Areas (CHMAs) are based on known woodland caribou use and habitat potential mapping; in addition, levels of both human-caused and wildfire disturbances were also taken into consideration. Tier 1 areas were selected because they include high-moderate caribou habitat potential with high levels of observed caribou use and low levels of human-caused disturbance. Tier 2 areas were selected because they include areas of high-moderate woodland caribou habitat potential with observed use and higher levels of wildfire and human-caused disturbance. Tier 3 areas provide general habitat and maintain habitat connectivity between Tier 1 and Tier 2 areas. These areas are not permanent: they will be updated as habitat conditions, land use and caribou populations change over time. Different strategies have been developed for each Tier based on their stated management objectives and relative importance to and known use by caribou, current habitat condition and potential risks. A two page overview of the SK2 West Woodland Caribou Range Plan and the CHMAs can be viewed here: https://publications.saskatchewan.ca/#/products/122354 Find out more about woodland caribou and what the province is doing to manage their habitat and protect their populations: https://www.saskatchewan.ca/business/environmental-protection-and-sustainability/wildlife-and-conservation/wildlife-species-at-risk/woodland-caribou-program

Caribou habitat management areas identify zones ("tiers") with similar importance to caribou, potential risks and primary strategies for caribou conservation.These Final Caribou Habitat Management Areas (CHMAs) are based on known woodland caribou use and habitat potential mapping; in addition, levels of both human-caused and wildfire disturbances were also taken into consideration. Tier 1 areas were selected because they include high-moderate caribou habitat potential with high levels of observed caribou use and low levels of human-caused disturbance. Tier 2 areas were selected because they include areas of high-moderate woodland caribou habitat potential with observed use and higher levels of wildfire and human-caused disturbance. Tier 3 areas provide general habitat and maintain habitat connectivity between Tier 1 and Tier 2 areas. These areas are not permanent: they will be updated as habitat conditions, land use and caribou populations change over time. Different strategies have been developed for each Tier based on their stated management objectives and relative importance to and known use by caribou, current habitat condition and potential risks.  A two page overview of the SK2 East Woodland Caribou Range Plan and the CHMAs can be viewed here: https://publications.saskatchewan.ca/api/v1/products/127215/formats/149989/download Find out more about woodland caribou and what the province is doing to manage their habitat and protect their populations: https://www.saskatchewan.ca/business/environmental-protection-and-sustainability/wildlife-and-conservation/wildlife-species-at-risk/woodland-caribou-program

Caribou habitat management areas identify zones ("tiers") with similar importance to caribou, potential risks and primary strategies for caribou conservation.These Final Caribou Habitat Management Areas (CHMAs) are based on known woodland caribou use and habitat potential mapping; in addition, levels of both human-caused and wildfire disturbances were also taken into consideration. Tier 1 areas were selected because they include high-moderate caribou habitat potential with high levels of observed caribou use and low levels of human-caused disturbance. Tier 2 areas were selected because they include areas of high-moderate woodland caribou habitat potential with observed use and higher levels of wildfire and human-caused disturbance. Tier 3 areas provide general habitat and maintain habitat connectivity between Tier 1 and Tier 2 areas. These areas are not permanent: they will be updated as habitat conditions, land use and caribou populations change over time. Different strategies have been developed for each Tier based on their stated management objectives and relative importance to and known use by caribou, current habitat condition and potential risks. A two page overview of the SK2 Central Woodland Caribou Range Plan and the CHMAs can be viewed here: https://publications.saskatchewan.ca/#/products/122353Find out more about woodland caribou and what the province is doing to manage their habitat and protect their populations: https://www.saskatchewan.ca/business/environmental-protection-and-sustainability/wildlife-and-conservation/wildlife-species-at-risk/woodland-caribou-program

Sectors and days for collecting waste, recyclable materials and compostable materials.attributs:ID - Unique identifierDAY1 - Sector collection day (see also DAY2 and DAY3) DAY2 - Sector collection day (see also DAY1 and DAY3) DAY3 - Sector collection day (see also DAY1 and DAY3) DAY3 - Sector collection day (see also DAY1 and DAY2) CALENDAR - Hyperlink to the sector collection calendar (see also DAY1 and DAY3)**This third party metadata element was translated using an automated translation tool (Amazon Translate).**

This layer is the current fire year burn severity classification for large fires (greater than 100 ha). Burn severity mapping is conducted using best available pre- and post-fire satellite multispectral imagery acquired by the MultiSpectral Instrument (MSI) aboard the Sentinel-2 satellite or the Operational Land Imager (OLI) sensor aboard the Landsat-8 and 9 satellites. Every attempt is made to use cloud, smoke, shadow and snow-free imagery that was acquired prior to September 30th. However, in late fire seasons imagery acquired after September 30th may be used. This layer is considered an interim product for the 1-year-later burn severity dataset (WHSE_FOREST_VEGETATION.VEG_BURN_SEVERITY_SP). Mapping conducted during the following growing season benefits from greater post-fire image availability and is expected to be more representative of tree mortality. #### Methodology: • Select suitable pre- and post-fire imagery or create a cloud/snow/smoke-free composite from multiple images scenes • Calculate normalized burn severity ratio (NBR) for pre- and post-fire images • Calculate difference NBR (dNBR) where dNBR = pre NBR – post NBR • Apply a scaling equation (dNBR_scaled = dNBR*1000 + 275)/5) • Apply BARC thresholds (76, 110, 187) to create a 4-class image (unburned, low severity, medium severity, and high severity) • Mask out water bodies using a satellite-derived water layer • Apply region-based filters to reduce noise • Confirm burn severity analysis results through visual quality control • Produce a vector dataset and apply Euclidian distance smoothing

Orders in Council (OIC) are regulations or legislative orders in relation to and authorized by an existing Act. This table identifies Yukon lands withdrawn from disposal, usually by Territorial Order in Council. In Corporate Spatial Warehouse (CSW) data is split out into spatial views by Act under which orders are authorized. The tables are comprehensive and include both active and expired orders. Spatial views show only the active data.In this table and spatial views, Regulations by Order in Council (OIC) are spatially represented to provide clarity regarding Yukon lands withdrawn from disposal. Spatial data is viewed by the Act under which the order is authorized. Not all orders are for withdrawal, different levels of withdrawal are common and not detailed in GIS attributes. It is important to read OIC documents for specific details ( [https://legislation.yukon.ca/legislation/page_a.html](https://legislation.yukon.ca:443/legislation/page_a.html) ).Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

The dataset contains projects that are currently, or have been, subject to environmental assessment review. Attributes include the project description, project phase, decision, and proponent name. This layer consists of points themed two ways: a. Project Phase- This theme consists of layers showing what phase each project is in - pre-EA, application review, post-decision, and withdrawn or terminated; and b. Project Type - This theme consists of nine layers that reflect the potential types of projects under review. This dataset is coming from the EAO Project Information Centre (EPIC) and is updated daily. For more information on any of the project points go to https://projects.eao.gov.bc.ca/.

Predicted Soil Great Group class as defined by the The Canadian System of Soil Classification (third edition).