Landsat-derived forest age for Canada 2022Satellite-based forest age map for 2022 across Canada's forested ecozones at a 30-m spatial resolution. Remotely sensed data from Landsat (disturbances, surface reflectance composites, forest structure) and MODIS (Gross Primary Production) are utilized to determine age. Age can be determined where disturbance can be identified directly (disturbance approach) or inferred using spectral information (recovery approach) or using inverted allometric equations to model age where there is no evidence of disturbance (allometric approach). The disturbance approach is based upon satellite data and mapped changes and is the most accurate. The recovery approach also avails upon satellite data plus logic regarding forest succession, with an accuracy that is greater than pure modeling. Given the lack of widespread recent disturbance over Canada's forests, the allometric approach is required over the greatest area (86.6%). Using information regarding realized heights and growth and yield modeling, ages are estimated where none are otherwise possible. Trees of all ages are mapped, with trees >150 years old combined in an - old tree - category. This product was developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS).See Maltman et al. (2023) for an overview of the methods, data, image processing, as well as information on agreement assessment using Canada's National Inventory (NFI). Maltman, J.C., Hermosilla, T., Wulder, M.A., Coops, N.C., White, J.C., 2023. Estimating and mapping forest age across Canada's forested ecosystems. Remote Sensing of Environment 290, 113529. ( Maltman et al. 2023).

Growing degree days (GDDs) are used to estimate the growth and development of plants and insects during the growing season. Growing Degree Day are computed by subtracting a base value temperature from the mean daily temperature and are assigned a value of zero if negative. Base temperatures are a point below which development does not occur for the organism in question. Growing Degree Day products are created for base 0, 5, 10 and 15 degrees Celsius.GDD values are only accumulated during the Growing Season, April 1 through October 31.

Fire weather refers to weather conditions that are conducive to fire. These conditions determine the fire season, which is the period(s) of the year during which fires are likely to start, spread and do sufficient damage to warrant organized fire suppression.The length of fire season is the difference between the start- and end-of-fire-season dates. These are defined by the Canadian Forest Fire Weather Index (FWI; http://cwfis.cfs.nrcan.gc.ca/) start-up and end dates. Start-up occurs when the station has been snow-free for 3 consecutive days, with noon temperatures of at least 12°C. For stations that do not report significant snow cover during the winter (i.e., less than 10 cm or snow-free for 75% of the days in January and February), start-up occurs when the mean daily temperature has been 6°C or higher for 3 consecutive days. The fire season ends with the onset of winter, generally following 7 consecutive days of snow cover. If there are no snow data, shutdown occurs following 7 consecutive days with noon temperatures lower than or equal to 5°C.Historical climate conditions were derived from the 1981–2010 Canadian Climate Normals. Future projections were computed using two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: difference in projected fire season length for the medium-term (2041-2070) under the RCP 8.5 (continued emissions increases) compared to reference period across Canada.

This dataset provides a Canada-wide map of vegetation height and the delineation of the northern forest limit. It is developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS). Vegetation height estimates were derived from ICESat-2 LiDAR observations, integrated with Landsat time series and topographic variables to model spatial patterns. The northern forest limit represents the transition between boreal forest and tundra, an ecologically significant zone for monitoring climate change impacts and biodiversity. Vegetation height was modeled for six time-periods including 1985-1995, 1990-2000, 1995-2005, 2000-2010, 2005-2015 and 2010-2021. Predictions for each time period represent the median conditions for that period. Predictions of height and the probability of canopy presence were generated using Random Forests models trained on spaceborne-lidar data collected by ICESat-2 from 2019-2021 and overlapping Landsat satellite imagery from 2010-2021. These Random Forests models were then applied to the entire archive of Landsat imagery, representing a period of ~35 years. This dataset provides spatially explicit prediction of vegetation height (m) along the Canadian northern forest limit at 30 m spatial resolution. Pixels with a low (< 50 %) probability of containing a vegetation canopy have been assigned a height of 0 m. The science and methods for this dataset were the result of a collaboration between the Canadian Forest Service of Natural Resources Canada, partnered with the Integrated Remote Sensing Studio (IRSS) in the Faculty of Forestry at the University of British Columbia. When using this data, please cite: Travers-Smith, H., Coops, N. C., Mulverhill, C., Wulder, M. A., Ignace, D., Lantz, T. C. (2024). Mapping vegetation height and identifying the northern forest limit across Canada using ICESat-2, Landsat time series and topographic data. Remote Sensing of Environment, 305, 114097. https://doi.org/10.1016/j.rse.2024.114097 (Travers-Smith et al. 2024). Additional details outlining application of the model to the time-series of Landsat data can be found here: Travers-Smith, H., Coops, N., Mulverhill, C., Wulder, M. A., Lantz, T. C., Ignace, D. (2025). Satellite observations reveal stable forest limits and shrub expansion across the Canadian forest-tundra ecotone. Environmental Research Letters, 20(10). https://doi.org/10.1088/1748-9326/adfc7f (Travers-Smith et al. 2025).

**NOTE** This dataset is going to be replaced by the Data Catalogue layer: [Forest Inventory Ground Plots - Public Access](https://catalogue.data.gov.bc.ca/dataset/6d6d115f-4cc2-4141-909e-3344b3a72bcf) This new layer links to the updated database for all Forest Analysis and Inventory Branch ground sample plots. Growth and Yield dataset is a provincial data set that comprised of Permanent Sample Plots (PSP). Researchers such as GY modellers and those wanting to know the position of all samples will use the all status view to better understand the spatial distribution of historic measurement data including samples that are currently destroyed or inactive

Drought is a deficiency in precipitation over an extended period, usually a season or more, resulting in a water shortage that has adverse impacts on vegetation, animals and/or people. The Climate Moisture Index (CMI) was calculated as the difference between annual precipitation and potential evapotranspiration (PET) – the potential loss of water vapour from a landscape covered by vegetation. Positive CMI values indicate wet or moist conditions and show that precipitation is sufficient to sustain a closed-canopy forest. Negative CMI values indicate dry conditions that, at best, can support discontinuous parkland-type forests. The CMI is well suited to evaluating moisture conditions in dry regions such as the Prairie Provinces and has been used for other ecological studies.Mean annual potential evapotranspiration (PET) was estimated for 30-year periods using the modified Penman-Monteith formulation of Hogg (1997), based on monthly 10-km gridded temperature data. Data shown on maps are 30-year averages. Historical values of CMI (1981-2010) were created by averaging annual CMI calculated from interpolated monthly temperature and precipitation data produced from climate station records. Future values of CMI were projected from downscaled monthly values of temperature and precipitation simulated using the Canadian Earth System Model version 2 (CanESM2) for two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: mean annual Climate Moisture Index across Canada for a reference period (1981-2010).Reference: Hogg, E.H. 1997. Temporal scaling of moisture and the forest-grassland boundary in western Canada. Agricultural and Forest Meteorology 84,115–122.

Fire weather refers to weather conditions that are conducive to fire. These conditions determine the fire season, which is the period(s) of the year during which fires are likely to start, spread and do sufficient damage to warrant organized fire suppression.The length of fire season is the difference between the start- and end-of-fire-season dates. These are defined by the Canadian Forest Fire Weather Index (FWI; http://cwfis.cfs.nrcan.gc.ca/) start-up and end dates. Start-up occurs when the station has been snow-free for 3 consecutive days, with noon temperatures of at least 12°C. For stations that do not report significant snow cover during the winter (i.e., less than 10 cm or snow-free for 75% of the days in January and February), start-up occurs when the mean daily temperature has been 6°C or higher for 3 consecutive days. The fire season ends with the onset of winter, generally following 7 consecutive days of snow cover. If there are no snow data, shutdown occurs following 7 consecutive days with noon temperatures lower than or equal to 5°C.Historical climate conditions were derived from the 1981–2010 Canadian Climate Normals. Future projections were computed using two different Representative Concentration Pathways (RCP). RCPs are different greenhouse gas concentration trajectories adopted by the Intergovernmental Panel on Climate Change (IPCC) for its fifth Assessment Report. RCP 2.6 (referred to as rapid emissions reductions) assumes that greenhouse gas concentrations peak between 2010-2020, with emissions declining thereafter. In the RCP 8.5 scenario (referred to as continued emissions increases) greenhouse gas concentrations continue to rise throughout the 21st century.Provided layer: difference in projected fire season length for the long-term (2071-2100) under the RCP 8.5 (continued emissions increases) compared to reference period across Canada.

Landsat-derived forest age for Canada 2022Satellite-based forest age map for 2022 across Canada's forested ecozones at a 30-m spatial resolution, developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS). Remotely sensed data from Landsat (disturbances, surface reflectance composites, forest structure) and MODIS (Gross Primary Production) are utilized to determine age. Age can be determined where disturbance can be identified directly (disturbance approach) or inferred using spectral information (recovery approach) or using inverted allometric equations to model age where there is no evidence of disturbance (allometric approach). The disturbance approach is based upon satellite data and mapped changes and is the most accurate. The recovery approach also avails upon satellite data plus logic regarding forest succession, with an accuracy that is greater than pure modeling. Given the lack of widespread recent disturbance over Canada's forests, the allometric approach is required over the greatest area (86.6%). Using information regarding realized heights and growth and yield modeling, ages are estimated where none are otherwise possible. Trees of all ages are mapped, with trees >150 years old combined in an - old tree - category.See Maltman et al. (2023) for an overview of the methods, data, image processing, as well as information on agreement assessment using Canada's National Inventory (NFI). Maltman, J.C., Hermosilla, T., Wulder, M.A., Coops, N.C., White, J.C., 2023. Estimating and mapping forest age across Canada's forested ecosystems. Remote Sensing of Environment 290, 113529. ( Maltman et al. 2023).

A building is a structure that has a roof and walls and stands more or less permanently in one place. Small buildings have only their location recorded. A 'building to scale' is a structure that has one dimension larger than 50 metres for the 1: 20,000 scale and larger than 30 metres for the 1: 10,000 scale. Their extents are recorded. This product requires the use of geographic information system (GIS) software.

Landsat-derived forest age for Canada 2022Satellite-based forest age map for 2022 across Canada's forested ecozones at a 30-m spatial resolution. It is developed within the framework of Canada’s National Terrestrial Ecosystem Monitoring System (NTEMS). Remotely sensed data from Landsat (disturbances, surface reflectance composites, forest structure) and MODIS (Gross Primary Production) are utilized to determine age. Age can be determined where disturbance can be identified directly (disturbance approach) or inferred using spectral information (recovery approach) or using inverted allometric equations to model age where there is no evidence of disturbance (allometric approach). The disturbance approach is based upon satellite data and mapped changes and is the most accurate. The recovery approach also avails upon satellite data plus logic regarding forest succession, with an accuracy that is greater than pure modeling. Given the lack of widespread recent disturbance over Canada's forests, the allometric approach is required over the greatest area (86.6%). Using information regarding realized heights and growth and yield modeling, ages are estimated where none are otherwise possible. Trees of all ages are mapped, with trees >150 years old combined in an - old tree - category.See Maltman et al. (2023) for an overview of the methods, data, image processing, as well as information on agreement assessment using Canada's National Inventory (NFI). Maltman, J.C., Hermosilla, T., Wulder, M.A., Coops, N.C., White, J.C., 2023. Estimating and mapping forest age across Canada's forested ecosystems. Remote Sensing of Environment 290, 113529. ( Maltman et al. 2023).