The data represents the relative cultivation intensity in the agricultural area of Alberta. Cultivation intensity refers to the frequency of cultivation associated with the following management systems: no till, conventional tillage and summerfallow. It is an estimate of the degree to which cultivation contributes to wind and water erosion. The classes shown on the map are ranked between 0 (lowest) and 1 (highest).This map was created in 2002 using ArcGIS.

The data represents the annual solar radiation in Alberta over the 30-year period from 1971 to 2000. A 30-year period is use to describe the present climate since it is enough time to filter out short-term fluctuation by is not dominated by any long-term trend in the climate. Daily total incoming solar radiation is measured in megajoules per square metre (MJ/m2). Southern Alberta receives the greatest amount of annual global solar radiation with the amount gradually decreasing as you move farther north. However, cropping is successful in the northern (Peace River) area of Alberta because the longer summer day length helps compensate for the less intense solar radiation. Cloud cover in the mountains will reduce the amount of solar radiation received there.The amount of solar radiation received at the earth's surface varies with two factors that depend on latitude: the angle of the sun's rays and the hours of daylight. The distance from the equator, and therefore the intensity of the sun's radiation has the greatest effect on climate. Canada's position in the northern portion of the earth's northern hemisphere means that it receives less solar radiation compared to countries near the equator. The northward decrease in solar radiation is also noticeable within Alberta. Temperatures are generally higher in southern Alberta in comparison to northern Alberta because the south receives more solar radiation. This resource was created using ArcGIS.

Canada’s NFI survey was designed to provide an unbiased probability sample of Canada’s forests for long-term strategic monitoring purposes. The target population is Canada’s entire non-Arctic land area. A National Terrestrial Monitoring Framework (NTMF) was created by establishing a systematic 4 km by 4 km sampling grid over all of Canada from a random offshore point. Prior to T0, NFI partners determined that the NFI program would be able to affordably achieve its mission by establishing a 2 km by 2 km (400 ha) “photo plot” at every fifth sampling point on the NTMF (i.e. every 20 km), thereby providing a one percent sample of the target population. This sampling intensity was considered sufficient for national reporting and possible to sustain over the long term with anticipated funding.Photo plots were established across Canada during 2000-2006 (T0). There are 26,139 photo plot survey locations on the 20 km by 20 km grid, of which 18,570 lie inside the target population area. For each photo plot, information is collected on land cover, land use, ownership and protection status.NFI photo plot survey data are stratified by “NFI Unit” for standard estimation and reporting purposes. NFI Units were created by the geographic intersection of Canada’s 10 provinces, 3 territories and 12 non-Arctic terrestrial ecozones. Estimates produced for NFI Units are rolled up to produce standard reports for ecozones, jurisdictions (provinces and territories) and Canada. Some NFI Units are too small to produce robust estimates for with the current sampling intensity, so NFI Unit estimates are not publicly reported. Prince Edward Island (PEI) Atlantic Maritime, for example, is PEI’s only NFI Unit and it is small (1% sampling intensity achieved with only 19 photo plots), so the NFI avoids publishing provincial reports. Information consumers are encouraged to use official statistics produced by provincial and territorial governments for the forests in their jurisdictions. Most provinces are large, however, and the current NFI sampling intensity is sufficient for producing robust NFI reports for those jurisdictions. Special estimation reports can be produced using different ecological or administrative strata, such as the Boreal Zone, or the Managed Forest.NFI photo plots are surveyed on a ten-year cycle. During first re-measurement (T1; 2008-2017), survey intensity was reduced to one photo plot every 40 km across northern Canada (Figure 3) because of budget limitations. The T2 survey (2018-2027) is currently underway.

Canada’s NFI survey was designed to provide an unbiased probability sample of Canada’s forests for long-term strategic monitoring purposes. The target population is Canada’s entire non-Arctic land area. A National Terrestrial Monitoring Framework (NTMF) was created by establishing a systematic 4 km by 4 km sampling grid over all of Canada from a random offshore point. Prior to T0, NFI partners determined that the NFI program would be able to affordably achieve its mission by establishing a 2 km by 2 km (400 ha) “photo plot” at every fifth sampling point on the NTMF (i.e. every 20 km), thereby providing a one percent sample of the target population. This sampling intensity was considered sufficient for national reporting and possible to sustain over the long term with anticipated funding.Photo plots were established across Canada during 2000-2006 (T0). There are 26,139 photo plot survey locations on the 20 km by 20 km grid, of which 18,570 lie inside the target population area. For each photo plot, information is collected on land cover, land use, ownership and protection status.NFI photo plot survey data are stratified by “NFI Unit” for standard estimation and reporting purposes. NFI Units were created by the geographic intersection of Canada’s 10 provinces, 3 territories and 12 non-Arctic terrestrial ecozones. Estimates produced for NFI Units are rolled up to produce standard reports for ecozones, jurisdictions (provinces and territories) and Canada. Some NFI Units are too small to produce robust estimates for with the current sampling intensity, so NFI Unit estimates are not publicly reported. Prince Edward Island (PEI) Atlantic Maritime, for example, is PEI’s only NFI Unit and it is small (1% sampling intensity achieved with only 19 photo plots), so the NFI avoids publishing provincial reports. Information consumers are encouraged to use official statistics produced by provincial and territorial governments for the forests in their jurisdictions. Most provinces are large, however, and the current NFI sampling intensity is sufficient for producing robust NFI reports for those jurisdictions. Special estimation reports can be produced using different ecological or administrative strata, such as the Boreal Zone, or the Managed Forest.NFI photo plots are surveyed on a ten-year cycle. During first re-measurement (T1; 2008-2017), survey intensity was reduced to one photo plot every 40 km across northern Canada (Figure 3) because of budget limitations. The T2 survey (2018-2027) is currently underway.

Canada’s NFI survey was designed to provide an unbiased probability sample of Canada’s forests for long-term strategic monitoring purposes. The target population is Canada’s entire non-Arctic land area. A National Terrestrial Monitoring Framework (NTMF) was created by establishing a systematic 4 km by 4 km sampling grid over all of Canada from a random offshore point. Prior to T0, NFI partners determined that the NFI program would be able to affordably achieve its mission by establishing a 2 km by 2 km (400 ha) “photo plot” at every fifth sampling point on the NTMF (i.e. every 20 km), thereby providing a one percent sample of the target population. This sampling intensity was considered sufficient for national reporting and possible to sustain over the long term with anticipated funding.Photo plots were established across Canada during 2000-2006 (T0). There are 26,139 photo plot survey locations on the 20 km by 20 km grid, of which 18,570 lie inside the target population area. For each photo plot, information is collected on land cover, land use, ownership and protection status.NFI photo plot survey data are stratified by “NFI Unit” for standard estimation and reporting purposes. NFI Units were created by the geographic intersection of Canada’s 10 provinces, 3 territories and 12 non-Arctic terrestrial ecozones. Estimates produced for NFI Units are rolled up to produce standard reports for ecozones, jurisdictions (provinces and territories) and Canada. Some NFI Units are too small to produce robust estimates for with the current sampling intensity, so NFI Unit estimates are not publicly reported. Prince Edward Island (PEI) Atlantic Maritime, for example, is PEI’s only NFI Unit and it is small (1% sampling intensity achieved with only 19 photo plots), so the NFI avoids publishing provincial reports. Information consumers are encouraged to use official statistics produced by provincial and territorial governments for the forests in their jurisdictions. Most provinces are large, however, and the current NFI sampling intensity is sufficient for producing robust NFI reports for those jurisdictions. Special estimation reports can be produced using different ecological or administrative strata, such as the Boreal Zone, or the Managed Forest.NFI photo plots are surveyed on a ten-year cycle. During first re-measurement (T1; 2008-2017), survey intensity was reduced to one photo plot every 40 km across northern Canada (Figure 3) because of budget limitations. The T2 survey (2018-2027) is currently underway.

Canada’s NFI survey was designed to provide an unbiased probability sample of Canada’s forests for long-term strategic monitoring purposes. The target population is Canada’s entire non-Arctic land area. A National Terrestrial Monitoring Framework (NTMF) was created by establishing a systematic 4 km by 4 km sampling grid over all of Canada from a random offshore point. Prior to T0, NFI partners determined that the NFI program would be able to affordably achieve its mission by establishing a 2 km by 2 km (400 ha) “photo plot” at every fifth sampling point on the NTMF (i.e. every 20 km), thereby providing a one percent sample of the target population. This sampling intensity was considered sufficient for national reporting and possible to sustain over the long term with anticipated funding.Photo plots were established across Canada during 2000-2006 (T0). There are 26,139 photo plot survey locations on the 20 km by 20 km grid, of which 18,570 lie inside the target population area. For each photo plot, information is collected on land cover, land use, ownership and protection status.NFI photo plot survey data are stratified by “NFI Unit” for standard estimation and reporting purposes. NFI Units were created by the geographic intersection of Canada’s 10 provinces, 3 territories and 12 non-Arctic terrestrial ecozones. Estimates produced for NFI Units are rolled up to produce standard reports for ecozones, jurisdictions (provinces and territories) and Canada. Some NFI Units are too small to produce robust estimates for with the current sampling intensity, so NFI Unit estimates are not publicly reported. Prince Edward Island (PEI) Atlantic Maritime, for example, is PEI’s only NFI Unit and it is small (1% sampling intensity achieved with only 19 photo plots), so the NFI avoids publishing provincial reports. Information consumers are encouraged to use official statistics produced by provincial and territorial governments for the forests in their jurisdictions. Most provinces are large, however, and the current NFI sampling intensity is sufficient for producing robust NFI reports for those jurisdictions. Special estimation reports can be produced using different ecological or administrative strata, such as the Boreal Zone, or the Managed Forest.NFI photo plots are surveyed on a ten-year cycle. During first re-measurement (T1; 2008-2017), survey intensity was reduced to one photo plot every 40 km across northern Canada (Figure 3) because of budget limitations. The T2 survey (2018-2027) is currently underway.

The Yukon is underlain by a great variety of rock types ranging in age from Early Proterozoic to Recent. The various rock types are characterized by different magnetic intensity and this map show those variations at the regional scale, with highly magnetic rocks represented by warm colours and non-magnetic rocks shown in cool colours. The First Vertical Derivative magnetic map highlights the magnetic intensity of near-surface features in the Earth's crust. This magnetic compilation was extracted from the compilation of Oneschuk et al. (2019). The data was gridded at 50 m.Magnetic data for Yukon can be obtained from: [http://gdrdap.agg.nrcan.gc.ca/](http://gdrdap.agg.nrcan.gc.ca/)Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

The Yukon is underlain by a great variety of rock types ranging in age from Early Proterozoic to Recent. The various rock types are characterized by different magnetic intensity and this map shows those variations at the regional scale, with highly magnetic rocks represented by warm colours and non-magnetic rocks shown in cool colours. The Residual Total Field magnetic map shows a measure of the total magnetic intensity in the Earth's crust. This magnetic compilation was extracted from the compilation of Oneschuk et al. (2019). The data was gridded at 50 m.Magnetic data for Yukon can be obtained from: [http://gdrdap.agg.nrcan.gc.ca/](http://gdrdap.agg.nrcan.gc.ca/)Distributed from [GeoYukon](https://yukon.ca/geoyukon) by the [Government of Yukon](https://yukon.ca/maps) . Discover more digital map data and interactive maps from Yukon's digital map data collection.For more information: [geomatics.help@yukon.ca](mailto:geomatics.help@yukon.ca)

Canada’s NFI survey was designed to provide an unbiased probability sample of Canada’s forests for long-term strategic monitoring purposes. The target population is Canada’s entire non-Arctic land area. A National Terrestrial Monitoring Framework (NTMF) was created by establishing a systematic 4 km by 4 km sampling grid over all of Canada from a random offshore point. Prior to T0, NFI partners determined that the NFI program would be able to affordably achieve its mission by establishing a 2 km by 2 km (400 ha) “photo plot” at every fifth sampling point on the NTMF (i.e. every 20 km), thereby providing a one percent sample of the target population. This sampling intensity was considered sufficient for national reporting and possible to sustain over the long term with anticipated funding.Photo plots were established across Canada during 2000-2006 (T0). There are 26,139 photo plot survey locations on the 20 km by 20 km grid, of which 18,570 lie inside the target population area. For each photo plot, information is collected on land cover, land use, ownership and protection status.NFI photo plot survey data are stratified by “NFI Unit” for standard estimation and reporting purposes. NFI Units were created by the geographic intersection of Canada’s 10 provinces, 3 territories and 12 non-Arctic terrestrial ecozones. Estimates produced for NFI Units are rolled up to produce standard reports for ecozones, jurisdictions (provinces and territories) and Canada. Some NFI Units are too small to produce robust estimates for with the current sampling intensity, so NFI Unit estimates are not publicly reported. Prince Edward Island (PEI) Atlantic Maritime, for example, is PEI’s only NFI Unit and it is small (1% sampling intensity achieved with only 19 photo plots), so the NFI avoids publishing provincial reports. Information consumers are encouraged to use official statistics produced by provincial and territorial governments for the forests in their jurisdictions. Most provinces are large, however, and the current NFI sampling intensity is sufficient for producing robust NFI reports for those jurisdictions. Special estimation reports can be produced using different ecological or administrative strata, such as the Boreal Zone, or the Managed Forest.NFI photo plots are surveyed on a ten-year cycle. During first re-measurement (T1; 2008-2017), survey intensity was reduced to one photo plot every 40 km across northern Canada (Figure 3) because of budget limitations. The T2 survey (2018-2027) is currently underway.

This map displays an assessment of soil erosion risk for the agricultural area of Alberta. Loss of protective residue cover through cultivation will increase the potential risk of soil erosion. The vulnerability of the soil to erosion combined with the intensity of cultivation determines the degree to which the soil may be at risk. The classes shown on the map were ranked from 0 (lowest risk) to 1 (highest risk). This resource was created in 2002 using ArcGIS.